开云体育

Is it possible to bring up the "My Contacts" list on a Tandberg C60 as opposed to the phonebook using the IR emulation command? I looked through the protocol doc but didn't see anything. Did I miss it

Can you establish a console? I'd try: - Installing the new OS via FTP. Not sure this is any more effective than via the PUF tool, but perhaps worth a shot? - From the Console run Initialize, then

Do they have a PC application that you can run and watch the MJPEG stream? If they do, you can run Wireshark and sniff out the ports they're using. Also, is this page useful:

Nick, Thanks for the reply, took all of these steps including power cycling the processor. Still cannot load a program. Am calling into Crestron now. Thanks again, Tray

There was a thread on here a few months ago where someone had written a driver to control a c4 system from Crestron. The searching on the yahoo forums is pretty lame but hopefully you can find it.

Answers below. . . From: Crestron@... [mailto:Crestron@...] On Behalf Of Christopher Sent: Thursday, June 20, 2013 12:57 PM To: Crestron@... Subject: [Crestron] S+

Thanks Mark. The dimmers aren't the issue as I will be doing the Crestron dimmers. I just need to make an MC3 or CP3 control the rest of the C4 product if possible. They have a distributed audio C4

Here are a few tidbits I have had to do with the new firmware: Reinstall the firmware using FTP method (even if it looks fine it may not be) Recompile all in Simpl and re-upload. Someone said replace

Thanks... Client decided to update her ARQ Music server to link to the mysqueezebox.com server. We'll see how that rolls.....

Can't load a program to MC3 with 1.007.0019 and TB 2.36.053. Toolbox chokes and stops the load attempt before it begins and says that no errors are returned. I reset the device but am doing this

OK folks, troubleshooting a recursion loop and need a little S+ sanity check... Summary question is if you have a wait/delay inside a change event, does the code after the wait/delay evaluate the

Hi All - I have been working with Onkyo/Integra and connecting via RS-232 for all of my installs. I didn't want support issues connecting via IP until all of the kinks were worked out. My questions

Fluke DTX-1800 CableAnalyzer per this document: http://www.crestron.com/downloads/pdf/misc/Cable_White_Paper.pdf

Hi Fabio, I don't know the model # off the top of my head & I'm on the road without it this week but I do know it's rather pricy (I want to say $10k-or-more-ish) so we only have one in the office;

Nevermind, figured it out with their tech support.

Yes, port 1702. I am pretty sure it tells you to send \x0A and not \x0D. The fb has a \x0D\x0A. If you are not controlling it, make sure you have a 2d on the client status fb and make

It is my understanding that Sirius/XM does not allow multiple simultaneous streams to Squeezebox. Starting a stream on the second will pause the first. But I cannot personally confirm this. I have

LMS will manage both players and you can get an independent stream from each one. How long the whole pile of crap will stay working without a stupid burp/hiccup/lockup is really the question to ask.

FYI, in case you didn't notice... Q-Sys Designer emulates the integration protocol for you, so you can test everything without actual hardware. What a concept! I love this feature... pretty much the

Anybody played around with one of these and or got it talking via RS232? I'm playing around with the protocol in the manual and not having any luck