开云体育

Initially looking at this, it is disappointing. The interface is not using retina graphics, items are not lineup correctly, and the demo is laughable.

Completely Agreed.

As soon as you enable a buffer, it spits out to all of the others which retriggers the others' logic, which fires up a loop. I think there must be a timeout that says "if one has changed, prohibit all

I was incredibly pleased with the performance. I did notice the lists on the weather object were scrolling ridiculously slow. I loaded a program into our office from home. Even over a remote

Its a process that isn't worth, its still in beta imo. Leave it there until its baked.

I was able to use it, but found some bugs. I had a bug with the Design explorer widndow. It wasn't populating until I clicked the gear, and checked show layout management control. I then had to create

Do-able? yes. Clean? no. When you transition from individual-values to shared-value, do you want them to wait for the next propagation to become synchronized? Or is it necessary to track the last

spitballing: room01#...room05# (analogs) enable_feature (digital)(logic to enable/disable this feature) aos room01#->room01_changed ... aos room05#->room05_changed abuf room01_changed

Use 5 ATOS's and an IL or INIT/EQU to track the last changed value, use ABUF/SBUF combos based on the last changed digitals as enables. That should do 'er

I can't even get a simple one PJ system to build. mps300 epson PJ xpanel 2.0 with 2 buttons, pj power on and power off Building gives this error and I can't even tell what device it can't make

I'm surprised to hear that - in general the performance I thought was much better. Perhaps if you wouldn't mind sending me a project to exhibit this. Is this a general consensus on this group?

Say I have five analogs. I want all of those analogs to be the same value, depending on which one changes last. This will be enabled or disabled, so that sometimes they will all be in line and other

Thanks Rich. That does make it better and just like any other iOS app purchase. Once I saw it as an in-app purchase I assumed (that dam word again) that it was per device. Dang assumptions. Guess

Thanks for the info. I checked with Apple an each AppleID can be associated with a maximum of 10 devices. If you have more than 10 you will have to create another AppleID (these appleIDs cannot be

The in-app purchases operate like most apps, it's a "per account" purchase so once you purchase it once for iPad #1, for every subsequent device you use the "Restore Purchase" option. So, in a

not in 1.09 but I've been using it successfully since it was in beta in 1.06 [Non-text portions of this message have been removed]

Unfortunately I'm offsite via VPN on a different subnet. USB currently not an option. I'm told by a colleague that it's accessible via the front panel though.

Yes, you just need to enter the password using the jog dial to access the menu. You can set the IP from there as well. Best regards, Staszek Krycki 7 cze 2013 17:03, "Lincoln King-Cliby"

Pretty sure the answer is no. You can always use the front USB port or if you're on the same /23 device discovery should do you well...

Has anyone in the group had success using the theme editor in the new Studio 1.09.013.00? Thanks, Paul