开云体育

Yeah, that's a "hook up and fire up debugger" type deal - see what the codec is saying back to the control system. I'm going with Neil on the username/password being different than it was before the

Are you controlling via RS-232 or TCP? Often the login credentials get reset after a Cisco firmware upgrade. <bernie.kattner@...>wrote: [Non-text portions of this message

I have Crestron DM system we installed for a customer which controls a Cisco C60 codec. Everything has been working fine until the customer decided to upgrade the C60 firmware (not suppose to without

Oooh, I like that idea. It's not going to happen this trip (not enough time before my next out-of-town project) but who knows -- hopefully I'll be back in this corner of the world again; I really like

I wish! It's an AMX job. They have modules for it, but a firmware change on the RackLink broke that too. Another reason to dislike it.

Slackers, 20 years later and the laziness continues!

So power is the *only* thing you're polling when it is off? And the response to the power poll is an ERR *and* the response you expect? - Chip

Have you tried the I2P module to see if it might save you some headaches? Some of 'em work, y'know? :) - Chip

This is a basic concept to be aware of when using crosspoints (and sometimes EISCs) in the upon connection to an ECROSS, a CCROSS propegates all of it's values from the input side to the output side

Agreed, this conversation was great, have been mulling how to do this for a lighting module the last few evenings and this really helped to eliminate a lot of over-complicated options.

Thank you for all the help everyone. These last two examples really helped by moving the abuf or aos, whatever is needed from the interface side to the room side of the x-point. Previously I had it in

not at all. I expect that the thing to do is to embrace CEC. There is a device I just learned about that is basically an IP/serial to CEC converter. Probably a good thing. http://rainshadowtech.com/

Is it bad of me to say that I am pleased to hear that I am not the only one smashing my face into a wall?

Dies anyone have experience using command fusion (simpl plus) from outside of their network. I have a DNS alias with port 8020 forwarded to my mc3, no dice. Thanks, any help would be great! Sent from

I have just wasted over an hour or so trying everything I can find on a UN19D4003 with the same results. Different protocols, different baud 115200 down to 4800, no luck with any of them. I can see a

I would say it is 1 of 2 issues: 1: RS-232 settings are wrong 2: RS-232 pin out wired wrong Female Stero, Plug,(3.5�) Rx 2 ----> 3 Tx Stereo Tx 3 <---- 2 Rx Plug Gnd 5 ----- 5 Gnd (3.5�) Thank you for

I see it go out in debugger, the TV does nothing, and Rx$ is still silent.

Hi Jason, My solution to this (it's buried deep inside our framework, but it's used in lots of places) is to pass each analog value (from the user interaction side) into an AOS, with say a 1 second

They are removing Studio from the class? Many they found out there are too many issue with it. wrote:

Gave it a few minutes of my time to see what it was all about. Haven't used it since.