开云体育

For those running Parallels, My mac have stock RAM 4G. am planing the upgrade to 8G, Anyone have any particular brand tested to get better performance on the Crestron Apps or overall? AM thinking that

Thanks guys for the help. I appreciate it. Thom

This might sound silly but have you reloaded the webpage? I know it sounds strange but I've had this exact issue before. Clearing temp files via CCleaner and Internet Options does nothing until I

Hey guys, We should be pulling some hardware from two job sites that we are upgrading. AV2 with Ethernet card (C2ENET1) 433 MHz 1way gateway Tps4L with aluminum frame (2) Also, I'll have a complete 12

This will only remove the 64-bit web Xpanel executables, which is valid if you can't get the xpanel to *fit*, but they have nothing to do with the panel design.

http://www.grandstream.com/products/ip-video-surveillance/gxv3500

I always used the device extender in Simpl successfully. I do however run across a problem about 25% of the time where the unit will not properly report battery levels at all, not even in its internal

This is something I use when updating webpages. Open command promt and enter the following ( ipconfig /flushdns ) this will make sure it will reload from the server. Albert From:

Is the reserved join for battery level 17507? I'm trying to indicate the current battery level on a MTX3 and am not having success. Thanks.

Depends on the way the trigger to whatever module you're using is written/intended to be used but generally "only once". Most SIMPL+ logic, for example, is edge triggered -- the action occurs on the

Yes, only nitpick is that the -transmitter- needs to be set to autoswitch (the out of the box default) to allow either VGA or HDMI to be connected; there is nothing in the scaler to switch...what

Quick one, if I tie the < digital output to a trigger email event will it send the email just once, or continually send it until the < is no longer high? Cheers

Yea I got one on eBay today for 65$. Am I the only one that has a stock pile of equipment left over from jobs and its never what I need.... ? Lol Thanks for the help y'all.

Perfect - exactly what I needed. Thanks Chip

ACOMP2 and a debounce to make sure the temp is stable before triggering the email? - Chip

What's the best way to trigger an event based on an analog output from a C2N-RTHS sensor? The sensor has one Temp and one Humidity output, and I'd like to send an email when temp gets below 12

I took a quick look while eating lunch after shoveling some snow… Disclaimer: I don't know anything about this device or its 7400 line S+ module. I did notice that it has been substantially modified

Also, I have had similar networking issues with using the LAN's PoE switch to supply PoE power to DMCO-55 cards, when connected, I would intermittently loose connection to CP2E, then disconnect PoE

I believe this install is Cisco from head to toe, with some very experienced network guys setting it up. I'm kind of curious about rolling back from 4.007. I know re-compile was necessary after 4.007,

All Static. Got burned and learned my lesson about avoiding host names years ago.