开云体育

ACOMP2 and a debounce to make sure the temp is stable before triggering the email? - Chip

What's the best way to trigger an event based on an analog output from a C2N-RTHS sensor? The sensor has one Temp and one Humidity output, and I'd like to send an email when temp gets below 12

I took a quick look while eating lunch after shoveling some snow… Disclaimer: I don't know anything about this device or its 7400 line S+ module. I did notice that it has been substantially modified

Also, I have had similar networking issues with using the LAN's PoE switch to supply PoE power to DMCO-55 cards, when connected, I would intermittently loose connection to CP2E, then disconnect PoE

I believe this install is Cisco from head to toe, with some very experienced network guys setting it up. I'm kind of curious about rolling back from 4.007. I know re-compile was necessary after 4.007,

All Static. Got burned and learned my lesson about avoiding host names years ago.

Just FYI, I just finished fighting the same type of issues. All of the sudden I had the same network problems with multiple, non-connected, systems. Come to find out, there were two main issues.

Most definitely will work. Use this setup for most of the conference rooms we install. -- Yours truly, Victor

Does anyone know if this will work... A dm wall plate and a dm scaler only. No processor. Set the scaler up for auto detect to allow vga or hdmi to be plugged in. Thoughts? Thanks Thom

Contact me on my personal mail Marselle001@... Crestron CAIP

The answer availble rg_2-series_control_systems.pdf in the crestron web site page 18/19. if your problem still exist let me know on my mail :marselle001@... Rabih Brahim Crestron CAIP

To Make the web xpanel work please follow the steps below: After Compile , open xpanel web folder and delete every file has 64 , mainly they are 2 files : XPanel64 XInit64 then it should work ! Rabih

hello every one, below is the model number of the IP camera Type: PTX model number is :PBACM - PT300 (3 MEGAPIXEL PTZ DOME CAMERA)

Good catch, I didn't see/read the "ST" part. Yep, must be the 1-way gateway.

Are you using static IPs in your IP Tables, or hostnames?

Have you tried disconnecting the panel from the network and then try to ping that address and the same for the DMPS? Check to see if you have an IP conflict.

Hi, Is there any programming required in Simpl Windows, should a keyboard or mouse be connected to the DGE1 with V12 panel? Also, is the VPG Glass Extender required in Simpl when using the V12 panel

Mark, it will work with the CNRFGWA-418. Ted

Good one, forgot about that. I have not had to mess with that setting in a while. There is other info really needed also. What DM firmare. Are you on your own network or the clients? What else is on

Thanks, but no go.