开云体育

Update: A couple months ago I was told to roll the processor back to 4.001 since the C2ENET-2 was locking up with 4.003. Updating the processor to 4.007 seems to have helped throughput for the B side

LogMeIn - it's free and works well. I believe we currently have in the neighborhood of 50 remote PCs deployed that are managed under a single account.

I found out my problem wish was selecting the Infinet insted of the Cresnet, but dont know were I select to load the project,

Dec 5-7 for myself [Non-text portions of this message have been removed]

I am trying this right now and I can see that is connected but a message of Status No Deceive Found. What I did goes as follows: Address book new entry called Dorado USB Remote. Indirect selected

Has anyone successfully done this?

As a veteran of multiple hurricanes and the accompanying power outages (and flooding), I can confirm that you will never forget that smell. Having a strong preference for seafood definitely doesn't

If you're above Lake Pontchartrain you are a northerner in my book. :-)

Guinea pig slot for me, Oct. 15-17th.

I have a dozen DGE-1s on the B port of a C2ENET-2. IE slowly loads some of the content on webpages, and then stops as if it is done. Crestron has no idea why. Does anyone happen to have any advice?

Is there documentation on how to poll a dd-wrt router?

+1. My 2007 46" Sharp doesn't blink at 1080p60 over component. The 46" JVC I bought a year or so back, not so much. But it *does* support 1080p30 on HDMI, which the Sharp doesn't. Go figure. - Chip

I've been trying to reach Erin for over a week, too, on an unrelated matter. She's usually pretty good about responding, so I'm guessing it has to do with what Nathan said. I'd say just keep trying

Yeah I am having that same issue right now. It certainly would seem that Crestron needs to work on their communications more than a little bit. I submitted my entrance exam for admission to

Again, there is a Serialize Time module in the files section from a year and a half ago. No offense but you people need to do some research before posting for modules. I see it all the time. TB

Strange, I emailed Erin right after the D3 class I took at the end of August- but got an OOO since it was labor day. I emailed early the next week and she sent me the official notice, and followed up

Thank you for the replies, and the congrats. Its funny you mention getting my rep involved, That is how I got them to finally check my test programs after waiting 3 1/2 months for results *sigh*.

Their distributor in Germany lists the GC100 template on the web site which is similar in functionality to the separate devices.

I have to say what Nathan stated is probably really correct. I am sure Erin and everyone is just slammed right now. Be patient and congratulations!!

There is a PJLink module on crestron's site. While it is over-bloated, you can use that for a starting point.