开云体育

Yea I had it all setup and spent 2 hours with TB on the phone. never got it working just now finishing redoing the program to run on the mc4 instead of the cp4.

They must be mistaken it for a 2 series or something? It shows in the program when you add it

Looking for some help. Was replacing an mc3 with mc4 as a slave for some lighting. I'm being told by TB that the gateway built into the mc4 isn't available when in slave mode. can anyone confirm this?

Maybe try clearing your cache or trying a different browser.

Pretty sure you could use a SIMPL processor for the Lutron communication, running Ultamation's SIMPL Home to connect to each of the Home systems. Set up which lighting goes to which Home system in

Ah brilliant! Why didn’t I think of that of that…

I don't know about the CH side of thins and if that may break things but this is pretty tropical with Lutron in commercial environments -- e.g. each room/building area controls only its area within

Each lutron processor can be linked to only one crestron home system. So if the lutron system has more than two processors, and conveniently have the lighting zones separared Into different

And also you cant connect via indirect connection to a DIN tstat drives me crazy. USB only cmon I can connect indirect to a 20+ year old keypad...

We have a resi job coming up that consists of an old (large) main farmhouse, plus a couple of outbuildings. There are lots of rooms in each of the three buildings, plus landscape lighting all round

Jeremy, Here is what I have done: 1) In Debugger, with the projector off, I sent to the projector via tx$, my name & saw the same response on the rx$ side (btw, the port is set at 19200) 2) I made a

Would it be too much to ask to have the connectivity method be the same as EVERY OTHER tool within Toolbox...????? Load an Address book, select the device from the address book drop-down, device

This only vaguely resembles valid S+. You should start by constructing valid commands for the projector, testing them in Debugger, then using them in a Serial IO symbol in

You are probably best off contacting the Fusion Support Group - fsg at crestron. [email protected]> wrote:

I hope it's on one of the top boards and you don't have to disassemble the unit to get to it. That product line, IIRC, is the one that later convinced Crestron to add a manufacturing engineer as

Hi All, Have an AMS system in a client's home that it seems determined the battery on the main board for the NVRAM is done. Has anyone replaced these before? and if so, what is the battery model? All

Not sure if this will help, or if it's too elaborate, but we use a lot of these in our newer builds. Allows for power/data/conduit to be routed into the backbox and provides a space for equipment to

IIUC you want both 120 V power and low voltage in the same box. There are dividers made for such purposes, for example WallSource 2-Gang Box, Divider and Mounting Brackets (

Has anyone had any luck utilizing the Visual Ai feature recently added to Crestron's 1beyond Camera platform? I moved everything up to the most recent firmware and see the tab on the web Ui of my

Thanks @Jeremy. That worked great. I had to play around to get the correct syntax to make it work but it works well. For reference here is the command I'm running from a SIO: xCommand UserInterface