开云体育

Hey Ryan, You can find an IR Driver for the Sony BZ30L range on Crestron’s Certified Driver website. https://drivers.crestron.io/rad/driver-search/5037%3Fmodel%3D9257 Cheers,

I can corroborate that...unfortunately.

"POWR 1\x0D" Sorry, fat fingered. ________________________________ Sent: Saturday, December 23, 2023 1:08 PM To: [email protected] <[email protected]> Subject: Re: [crestron] Sharp 4P-B86EJ2U

My experience with Sharp displays is that the power commands can be either "POWR 01\x0D" or "POWR1 \x0D" for POWER ON and "POWR 0\x0D" or "POWR0 \x0D" for POWER OFF. You may also have to send "RSPW1

all good. yes, literally POWR? ?0\x0D and POWR? ?1\x0D. Going to resume work on this next week.

I would use RS232 one way driver on an IR port to the 3.5mm Jack. Much more reliable than a bug that could fall off. The BZ range is standard code but make sure you send the enable string whilst the

When you said you’re sending CR, you’re not actually literally sending that are you? Should be \x0D (apologies if you knew that already!)

yep. did that too. im kinda at a loss

Baud rate 9600, the tv also has the ability to change the baud rate in the menu settings, you have to set that to 9600 too

ya, POWR? ?0CR and POWR? ?1CR is what we're using. Its acting like it isnt receiving a command however im getting responses in debugger and putty. feeling like its a setting in the display but

CORRECTION POWR NOR PWR

Just did one, going by memory, I think the commands were: PWR[3spaces]1 then the CR, power off replace 1 with 0 the manual has all the info

Check to see if you have Horizon keypads in your program. We've been having the similar issues loading programs and we found a Crestron article from October detailing that there is an issue with D3

For what it's worth, we did a takeover job with a Sharp LC-60LE751K. The only notable thing that I recall was that there was an RS232 to TTL converter between the COM port and the display. Baud rate

Hey All Has anyone successfully gotten control via 232 or LAN? If so, how? We've been through all the display settings but can not get it to work, though it seems we are communicating. Same results

Yup. Also had a strange issue with a brand new laptop. D3 will not compile correctly. Had to save it in dropbox, open it up in my old laptop which the power connection is literally hanging out,

Yeah, saw that. On a more positive note BACnet does seem to be improved.

...another firmware update with another supposed fix that doesn't fix it :(

Have you tried the consumer codes? ?RS-232 codes look the same as consumer, maybe the IR is the same . . .

o o.. I hope this can help then. You need to to manually save the IR commands and utilize then. https://www.crestron.com/Products/Control-Hardware-Software/Hardware/Accessories/CSP-LIR-USB I hope this