开云体育

I use the clock driver to astronomical clock, output feeds time offsets then one shots trigger the light(s). Technically I have some logic in between to determine the season because 30 min before

Hey guys , I do have a client that wants the outdoor lights to turn on 30mins before sunset Any idea on how to do this ? Thanks , Mingo

thanks dears for information I will generate a license for the processor but I do not have any license already to be deleted or do I need to delete something equipped with the processor. also I tried

I have an AV3 that is not communicating. No LAN light on the front but network activity on the port and on the network switch. I changed to DHCP and it is not acquiring an IP. Errlog reports the

I just RMA'd a AV3 because it would stop talking to Lutron.? Delete license, get a new one and everything was good for 6 months until it did it again.? Same fix as before.? They sent me an advanced

Anyone dealt with the new Sony Z Series Displays? I have tried CEC, IR (several drivers), RS232. nothing. Even other Sony tv remotes wouldn't control the tv (just power toggle, but no menu or other

Should not be too hard to fix.? Once you find the offending module open it, search for the variable LOCAL, and rename it to something else like LOCAL2.? Sometime in the past, LOCAL wasn't a reserved

BTW, the #2 needs to be there if you are using the latest update of the scheduler.

You need to also look at the .dat file.? There needs to be what appears to be an errant line at the very top,? #2, and the file MUST be in the NVRam folder on the processor and in the subfolder for

I've seen a couple of defective 4232CBMs, however if that were the case the older module wouldn't work. I'd suspect either the alarm panel's or the 4232CBM's firmware needs to be updated. I can't

Hello Evan, I have only one event in the .dat file to trigger the hard reset at 3am, I tried only Saturday’s, tried everyday and still nothing. I user text console to set time to a few minutes

Hello Lincoln, Not hard resetting for any issue related reason, I just want to reduce the runtime so that I do not have 180 days plus of uptime. My main objective is to just have my system uptime

Generally if you’re resetting a processor with any frequency, let alone daily, it’s a symptom of a bigger issue that you should really track down and fix first. I have many processors with a

the scheduler can only kick off one event at a time so if you have 3 events that need to happen at 8:15 it will only do the last one.? Found that out with my thermostats.? had to separate them by a

Hello All, I’m looking for everyone’s opinion on doing a hardware reset on my 3 series processors Automatically everyday at 3am. I was trying to use the event scheduler to perform the Hardware

I'm not in front of it right now, but I'm using it with a PRO3 and it's been working for quite some time in other locations as well.

Thanks for the replies (BB, Jeremy, Steve) BB - tried ... no luck Jeremy - tried ... no luck ... dont want to back load SW as my other programs would suffer... Steve - best advice... i didn't think of

I believed I seen this back years ago in one of my programs.? It turned out to be signal in a module that was named "LOCAL" -- it wasn't even a module that I wrote.? If you do have a signal named

Most common cause is not recompiling the SIMPL program properly. *FW v1.603.0113 requires SIMPL program running must be compiled with DevDB 91 [Jul.2020] or later.* *Also make sure you use Recompile

Hi, any luck with this?