开云体育

thats very kind of you. i dont think i have your full emai. mine is chap@...

I can't seem to get this integration done. Is the fix for the Sonos 9.0 f/w working correctly? I have not integrated Sonos before but I've done so successfully with Autonomics so I'm familiar with

No problem with Sonos App running. I can take a look at Your program if You want. Just send me the archive along with MAC addresses and IPs of Sonos Players.

Thanks! I have tried it on my test setup and it wont switch. I have a sonos app running on my pc at the same time, will that screw it up?

Hi Phil, I created a small example with power and input control for the LG using SNMP, saved in https://groups.yahoo.com/neo/groups/Crestron/files/Programs/

Dear all, Anybody have a sample Crestron program with fusion energy monitoring (Gas, electrical power, Hot water, cold water?) Regards, Mohit

The DM upgrade tool used to provide an option get them when updating a 4 card pack to singles in a 16x16 but I’ve been unable to get that to work recently do to a java error (I tiried at least 4

With the issues coming up with Sonos and Crestron I would assume that there hasn't been much thought into the Heos (from the point of view that Sonos dominates the market more than Heos). We try to

Hi, Yes, it does (tested with 9.0.1). No, if You create the group from the target zone (target zone means, the zone where You want to listen line-in). In this case whole group plays line-in. Otherwise

Has anyone done the SIMPL# programming necessary to establish TLS communication and then wrapped it in a SIMPL+ or SIMPL module? I need a SIMPL/SIMPL+ module that can input IP address and port and

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the Crestron group. File : /IR Drivers/Toshiba TF-50A810U19.ir Uploaded by : metdeathx

Hey Crestronfreak55! Thanks for your response. File is loaded to Documents section of Files. I ended up working through a workaround to get good old reliable RS232 to the displays with the system's

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the Crestron group. File : /Documents/webOS_SNMP_Command_UserGuide_V1.6.pdf Uploaded by :

I saw it with a Pac2 that somehow jumped into slave mode while I was setting up cresnet ids for keypads. Once I took it back out of slave mode it was fine again

I saw this recently with a PMC3 on the cresnet (thermostat) showed as null. I rebooted, reloaded firmware, and then swapped for a MC3 I bought off of ebay (buddy's house).

I recently purchased 2 new in box DMC-CO-HD-PA 8G+ output cards for a home project only to find out upon receiving that neither came with faceplates. Various search attempts have failed to turn up

I’ve seen it happen with an ancient device that didn’t report precisely as Toolbox expected it (iirc, it was a CNECI-4 or CNECI-4a where Toolbox was expecting it to report CNECI-4A If you

Does anyone know why I am getting a Null folder on my network device tree view? Cresnet devices are reporting fine, but non of the ethernet devices are reporting. However, the processor is connected

couple of questions- does this work with Sonos 9.0 firmware? if the zone is in a group will it pull out of the group? What is the MAC address format? TIA Chap Cory

Hellow every one I downloaded the Heos Denon module because I want to integrate a Heos Likn and Heos Amp for a client but I'm not sure if the module that is in the crestron market works, I tried to