开云体育

Has anyone attempted to control the Pentair Intellitouch or Easytouch using the Screenlogic Protocol Adapter? Pretty sure this is a long shot and there's no drivers or documented commands, but it does

Did you recompile the program with the new device database?

Do you happen to mean Pioneer? I am having trouble finding rs232 codes for it too. From: lthew <leethew@...> Reply-To: <Crestron@...> Date: Wednesday, June 12, 2013 8:01 AM To:

Does any one resolve the problem?

I have the following problem, I made him an update to the firmware v4.007.0004 AV2 processor and all CLS-C6 stopped giving me feedback. I did it in two different places and I feel the same. Then i

What about things like Ring Indicator and Carrier Detect? (Not that those matter to us, but I thought they were part of the spec?) - Chip

Hmmm... Has a nice ring to it... - Chip

Chips House of Masterful Programming and Integrated Technologies - ChompIT for short. Sent from my eMail.

Yes, worked fine for 2 months then issues.. Master IP entry for my slave looks like this: 65 192.168.001.079 slave 00 41794 cip online OP

Does a Mac xPanel suffer from this as well?

Do you know if menu 1999 work to go to the factory menu to reset the rs232 port.

Good one... ;)

RS232 by definition doesn't support anything beyond 5 wires max for RX, TX, GND, CTS & RTS. I have seen all kinda of issues with NEC E series displays bing VERY picky about the peak voltage the

Yes, this works with a full 9-pin cable using a full DB9 com port. But as anyone been able to control these with the usual 2,3,5? The monitor has a 4-position 2.5mm jack, with a supplied 2.5mm -

Not old and cranky Heath, Just "well seasoned and spicy" ;)

are you guys setting the ip tables right? When you have a 2 series slave (whether the master is 2 or 3 series), the IPT in the master must have the IP Address of the slave. If the slave is 2 series,

Nope, it was not done. Perhaps OP had an old xpanel that they recompiled and it dragged in all the xpanel 64 bit stuff too, that makes things much bigger and causes fitting problems.

I'm running a custom theme I built from scratch. Problem could be that the theme wasn't compiled after the app was released. Try importing the theme into studio and (latest version) compile and

Glad it worked!

Awesome! That saved me a ton to head-aches. I'd never even noticed that option before.... <btrujillo4343@...> wrote: