开云体育

I have done many of these systems, and I can tell you the way I deal with it... Button press 1-6 (inputs) to Interlock 1-6 to 1-6fb 1-6fb to Analog Initialize 0-6d to Select Video HDMI Out 1, Select

Do a search for V24 on the Yahoo group. I posted a short step-by-step for setting up a V24 with a DGE-2 and a DM-TX probably a month and a half ago or so.

I have the same thing going with multiple 750s on a current project. The presses are getting through but there's no feedback. Page flips also don't work.

Just thought, but I have to ask. I continue to simply use a Cisco router RV042/82/16 as my gateway for my installed systems. In the past I just find it easier from a service and installation POV if

Always seems to be EISC - signals pulse constantly high then low, high then low, until the processor is rebooted. Seems to be different processors too!? Very random - and very annoying.

for all of the different possibilities, I would need a lot of analog equate blocks. So, in order to try and clean up the program a bit, I thought of putting all of the analog equate logic into a

Check in debugger and see if your presses are getting through. Heath Volmer Digital Domain Systems Littleton, CO

I had dap8rc that would lose all but left and right. It would just happen at some time, the client was no help with nailing that down. Firmware reload would restore surround sound. Later it would fail

Yesterday I was on site and just making some changes to the program to the MC3 and then noticed that I both of my TSW was non responsive. I looked at the MC3 and it show that the IPT and it show on

We have had lock up problems w/ the TSW-750s as well. Pulling the netwrok cable will reset the unit. It's very sporadic as well. -Paul

Did you set DIGITAL LINK as the serial input on the projector?

I'm curious: Are they locking up or are they just not responding to feedback? We've had plenty of problems with this. - Heath -

Has anyone else had this problem. I have a theater that has the following. ADMS-BR HD-MD8X1 C2N-DAP8 CNAMPX-7X200 We just changed out the ADMS-BR to a ADMS-G2 and added a OPPO BDP-103. I have the

When you route signal to the DM out does the FB correspond to the value being sent? Also if you are running seperate inits for all your outputs you can route a working one (HDMI out 1 or 2) to the DM

I have a job with four in the system and they have all disconnected from the processor a couple of times, normally after an upload and even though in toolbox they say they are online.

Why would you make a module, instead of just putting in an analog equate?

Marc, Did you still happen to have this battery?

Chip, I took a look at your module last night, and it appears to work quite well. I do have a question regarding it though. Your module outputs an analog signal, and the feedback required to drive the

Gary, Judging by how this module works, I would like to say that it would work, but Chip had better verify it.

I figured I would contribute since you guys have helped me out many times. I uploaded a vtp file to the graphics section that is an example of a MPC-M20 button panel. You can delete the buttons you