开云体育

So it goes both ways I see. :) Though buffers have their place, there are many times when buffers are so much easier than breaking out crosspoints that it makes sense to use them. It depends upon the

I seem to have had more IR problems with the DVR versions than the non-DVR ones. Gaffer's tape + a pinhole helped.

I have been programming for a few years but have not been in a position to do it full time, I am really a lead install tech that can also program. I would like some input from the group on how to

Thank you for all the help, the IR emitter had to be moved a couple of inches away from the eye ________________________________ To: Crestron@... Sent: Friday, April 13, 2012 7:50 AM

Does anyone have an RS-232 or IP module to control this unit? Thanks Don

Is the module completely Simpl+? Having not used a MC3 yet all I can tell you is that if you are using anything that uses ticks for timing it will cause timing issues. This is because a tick in the

Any luck learning this, the remote that came with my hopper is rf only, no switch in the remote battery compartment

If I have more time on a next project with this remote I will give it a tried again within SIMPL side, but this project is not in time frame to test.

Except there is no vcbutton command and the camera command doesn't have a for-content option in the QDX.

I also prefer to keep stuff like this in Simpl, because it's easier to make changes later - especially if there are multiple remotes or touchpanels.

I want to see the commands been sent from a controller, then copy those strings to use from Crestron. You suggesting running the controller through the com ports on a processor (QM-RMC, connect A to

Well, I just updated the PTX-3, with the hard button manage assigned the joins to proper command EX: join 10= Cable box #1. and work OK, so far, the only problem is that takes time to goo true all the

I started out using the hard button manager but have switched to buffers. I have found it makes it easier to transition between different remotes or touch-panels and not have to redo all of the code.

What do you mean ? a nice qm-rmc :P

Can anyone recommend a good serial port sniffer?

Use either one you want, there's no functional difference. I prefer buffers personally because I'm used to hardbuttons always sending the same joins, and when I reassign them I tend to forget about

Hi All, I have a Simpl+ module that I wrote for an IP controlled device, it works fine with my Cp2E processor in the office. - However - when It got sent out to a client site that has an MC3 in it -

For the content issue you need to assign the correct camera for the content in hdx7000 the content camera is input 3, just sent those command: vcbutton map 3\r camera for-content 3\r if the

They have a conference software suite to control the microphone system, which can link up by either com or lan. Is there a way I could see what commands are being sent? That way it would help my

Never program a QDX Unit but i've done some hdx7000 thru tcp/ip with success. Using port 24 work great. (Need to sent the password to be able to control it via tcp)