开云体育

Yes, i've done this in the past to monitoring a device. you could write a little program to be able to change the communication setting and your all set. With a xpanel to adjust each parameter and

If you haven't dealt much with analog symbols I would start learning them. I program as much in analog as possible. It provides more power and flexibility. For instance, I NEVER use interlocks

Too true, too true...

Is there a way to add the CLI-120n-4 modules to D3 pro? ive been using simpl windows to control the modules but am interested in using d3 pro since i have a spare processor i could use for strictly

Handy reference here: Teach Yourself Programming in Ten Years: http://norvig.com/21-days.html Specific to Crestron, make sure you get to training classes, as they will teach you things that are

So you want to write another systembuilder?

So it goes both ways I see. :) Though buffers have their place, there are many times when buffers are so much easier than breaking out crosspoints that it makes sense to use them. It depends upon the

I seem to have had more IR problems with the DVR versions than the non-DVR ones. Gaffer's tape + a pinhole helped.

I have been programming for a few years but have not been in a position to do it full time, I am really a lead install tech that can also program. I would like some input from the group on how to

Thank you for all the help, the IR emitter had to be moved a couple of inches away from the eye ________________________________ To: Crestron@... Sent: Friday, April 13, 2012 7:50 AM

Does anyone have an RS-232 or IP module to control this unit? Thanks Don

Is the module completely Simpl+? Having not used a MC3 yet all I can tell you is that if you are using anything that uses ticks for timing it will cause timing issues. This is because a tick in the

Any luck learning this, the remote that came with my hopper is rf only, no switch in the remote battery compartment

If I have more time on a next project with this remote I will give it a tried again within SIMPL side, but this project is not in time frame to test.

Except there is no vcbutton command and the camera command doesn't have a for-content option in the QDX.

I also prefer to keep stuff like this in Simpl, because it's easier to make changes later - especially if there are multiple remotes or touchpanels.

I want to see the commands been sent from a controller, then copy those strings to use from Crestron. You suggesting running the controller through the com ports on a processor (QM-RMC, connect A to

Well, I just updated the PTX-3, with the hard button manage assigned the joins to proper command EX: join 10= Cable box #1. and work OK, so far, the only problem is that takes time to goo true all the

I started out using the hard button manager but have switched to buffers. I have found it makes it easier to transition between different remotes or touch-panels and not have to redo all of the code.

What do you mean ? a nice qm-rmc :P