开云体育

All good now, silly mistake. Changed IP address of my controller and didn't reflect that in the Comm Manager. So H&T Gen 3 works!

http://10.0.2.24:9000/plus-ht/sensor/temperature/${ev.tF}/ http://10.0.2.24:9000/plus-ht/sensor/humidity/${ev.rh}/

Hi Jeffrey, Send me what you have set for the url actions.? That is the most likely issue. Thanks Jay

Does anyone know of or have a module for SIMPL for control of a Honeywell Resideo T6 Pro Smart thermostat? Cheers, Michael . . .

@jbasen, Just received a Shelly H&T Gen 3 and realizing it may be different from a Shelly Plus H&T. Cannot seem to get any reporting of temp/humidity. I did set the URL actions, but still no data

Personally, I would use a garage door magnetic contact for this. I've had great success with these Seco-Larm SM-226L-3Q Overhead Door Magnetic Contact, 2.75-inch Gap, Open/Closed Loop Circuits (3

That’s why I just delete the DLLs rather than the entire folder – it’s enough to stop the program from being able to restart itself but not quite thermonuclear. -- Lincoln King-Cliby Commercial

Thank you very much

YoLink is a smart home product line offered by YoSmart.? YoLink devices provide up to 1/4 mile of range because of their use of LoRa wireless communications technology.? My latest article looks at

I also notice on most of the 4 series processors when I connect to them in System Info. it takes a few minutes to populate all the info fields. It will populate up to Slot 1 and show progress batr to

Using the web interface and stopping the program is just as unreliable as using toolbox and text console. Its luck of the draw if it stops cleanly or not. I would rather not delete the program folder

I've been using the web interface to load programs on the 4 series processors. It works reliably most of the time.

I've experienced similiar issues myself.? Based on some other rumblings in this particular forum other have suggested that this maybe either a f/w level issue or a toolbox issue.? I've tried a

My occurrences of this are substantially lower than a few months ago but I am still seeing it. Generally extended delays (more than a few minutes) are on the Toolbox side, not the processor side

Hi David, I haven’t used Sonos with CH at all and the projects that we have used Sonos on with Simpl systems, were changed over to MMS units for one reason or another. Pat M From:

What's the current best practice on stopping the program (so you can load new code)? I've been using... PROGREG -p:1 -u KILLPROG -p:1 But I see an old post where Dave H recommended... STOPPROG -P:#

Hey i at lunch did some digging maybe this helps https://github.com/tetienne/somfy-open-api [email protected]> wrote:

https://github.com/Nickduino/Pi-Somfy Start digging on github as well [email protected]> wrote:

Yeah, TB has it documented here: https://community.crestron.com/s/article/2845

support.controlconcepts.net