开云体育

I see what you did there, Brian!! Good One!!!...:) I agree with Brian about this. I pretty much never use slave/remote devices for 3/4-way circuits, because you always seem to need a 'keypad' where

Just curious if anyone is using the "offline" output on the Sonos Device module.? I haven't seen a case yet when a Sonos end point gets dropped and the "offline" output doesn't go high.? I would

About 50% of my systems are like that... The other 50% are a problem... Haven't found anything unique about them...3 and 4-series, various FW versions, various vintages, various network hardware,

Hi Brian! Thanks for the reply. ?So, which of the Apex/Aux/SWEX ?are best for my use case? ?In fact, thinking about it. ?Is there any reason, save the Crestron system going down, to use the

You can add as many KPEX devices as you want and just make them "programmatically" control the load. Just connect them to hot power only and ignore the traveler. We do this quite often with the Cameo

This is all really odd, as I have several (probably 20) systems out there running Sonos, with no issues. I've had a few fail, but after they are replaced with a Port they March on, without a

Hoping this is not too off topic but have you utilized AirMedia with a Flex Zoom Room system? I have followed all the guides to put the AirMedia into "Flex Mode" but I cannot seem to get the Flex

Using matt_rasmussen_2000's Roku 3 Series release module fromt he file section and it works great but getting a bunch of exceptions in the error log. A sample of the errors: 381. Error:

Hi All! I have the above hard wired wall switches, in a working lighting situation. ?I read the the Hz2 Dimmers and the Aux or KPEX are Gggod with up to a 4 way circuit. ?Any advice on a workaround

Yea agreed. ?we dont really work with 2 series anymore. ?they are so old that you wind up spending too much time troubleshooting. It's more cost effective to just replace it with a modern processor

I think in most cases, the it makes no difference if you erase first or just over write the program.? My understanding of the file system with flash is when ever you erase or replace a file, the

Still learning and have a question on loading new and/or updated programs to the control processor, in this case a 2-series on the AMS-AIP. What is the best practice when loading/updating the program,

I rarely integrate for clients because of past experience. I do have Sonos integrated at home and used to have issues with communications failing but for the last couple of years the only time I might

After reading the article, I'm not surprised I can't get it working.? If I'm reading this correctly, the new module is strictly smart graphics compatible.? the original system has 2 TPS4500's, 2

We ALWAYS spec Autonomics.? We install Sonos when Client is stubborn, and will not listen about it's limitations.

Any known issues with controlling Autonomics? I am assuming it's much more stable than Sonos right?

From their website Michael Restrepo | Owner Restrepo Innovations 825 Windham Court North Wyckoff, NJ 07481 Office | 201.925.0059 Direct | 201.952.4624 Email | mike@... Elite Pro

Awesome Thank you.

Same place you add a touch panel. You can add a MMS

Thanks for the link. I apologize what do you mean for built in hardware definition?