开云体育

You can power it off of the Cresnet port. Be aware that the processor with cards can require more than 75w.

Interesting, I had a project recently that used an 8x8 that we updated to the latest FW. We had an LG TV. I started out using the LX series driver from the CresDB, which I've used a number of times

FYI, I believe that you can power the P2+3 by feeding power into the Cresnet connector...I'm going off very old memory...

Well, I didn't have THAT issue... However, Earlier this week we added a new ATV to an older DM32x32 system. When sending IR out of the Endpoint, it was sending commands for about 2 sec. I really

I just noticed this the other day. I am going to try the one I have at home

Inside, no. The Pro2 has a 65w power supply that Crestron runs as a 75w. The Pro3 has a 180w power supply in it.

Will a Pro2 power supply work in a Pro3???

Tried these command sand they didn’t work. Very unusual. Only the \x01 starting commands work. Must be different commands in this camera. thank your for your help and response though

Sorry this will work

in visca serial entry in the SRGX module you need to send: Preset1: \x8x\01\04\3F\02\00\FF Preset2: \x8x\01\04\3F\02\01\FF Preset3: \x8x\01\04\3F\02\02\FF

I’ve tried the \x8x commands and none work. the commands from the module started with \x01

Yes SGRX you can send direct command in the visca input, work great !

Did you use a module from the application market? there’s a dip switch with http or rtsp but no udp dip switch

I do and SRG-A last week and there is a switch on the camera for UDP control

Hi Jeremy, Did anyone ever get back to you?? I'm using Visca over IP commands but can't get the Crestron VC4-PC3 to connect on UDP Port 52381. -- Doug G

Hi Ben, what do you mean by the jumper? I have a cable in the Lan and PTZ controls are working g but presets aren’t.

Did you put the jumper in the good position?

I was thinking I might just add in a few fake boxes to make these gaps, though I assume it would whine about that since they would be missing. Last night, I adopted 4 units into Director as a test 2x2

Hi All, Has anyone had experience controlling the Sony SRG X400 cameras? I’ve tried using the?Sony_BRC-X400_SRG-X_series module on the application market. Couldn’t get it to control via UDP. I

Yes, you can edit the XML and it doesn't have to be condensed to a single line. No, you cannot have gaps, which is really annoying, especially if you tend to organize things in groups and leave room