开云体育

I have not seen this behavior **except** if there’s a transfer program dialog box lurking in the background (annoying ‘feature’ of SIMPL for a couple decades is that this dialog acts as a modal

Anyone come across this problem in SIMPL? When I try to insert a new signal/parameter (or multiple instances) in Stepper, nothing happens. The frustrating part is that, sometimes it works and

Uh, would you believe it was an April Fools joke? Made you look!

https://www.sparkfun.com/products/449 or https://www.sparkfun.com/products/11189 would work. https://forum.arduino.cc/t/esp32-rs232-ttl-serial-communication/579886 gives more info on the code side.?

It definitely causes problems when your shitter is unlevel.

Ok I give up. I searched far and wide for a “level shitter” and couldn’t find anything. Where does one find such a device?

Nevermind, problem is solved. I polled for the DisplayMode in the driver and all the various aspect ratios showed up. Nice!

I'm using?Crestron Certified Drivers Display Ethernet to control my Epson projector, managed to turn it on and off with no problem, but I have one feature that I needed badly -- adjust the ASPECT

I've been playing with ESP32's recently and made a custom compass display for my motorcycle. I ended up adding a clock since the?GPS NEO-6M module spit the clock info out anyway and it updates every

I just did a deployment with that switch. It's NVX and Dante all on the same switch and is working well. Can you share exactly what you configured? Do you have a configuration of the switch you can

I cannot speak for the CBS350, but I have successfully used the lower cost CBS250 series with NVX.? Although it was a pretty simple NVX system with all NVX on the same switch. I should note that the

It sounds like the flash is pooched. I've had success with replacing the 4GB MicroSD card and loading an "good" image from any x52 series TP's. They all seem to use the same code. Hope this helps!

Hi All, Anyone seen this issue, and have a fix for it? After aprox. 5-6 project load/updates, the 1052 panels go to *eternal* 'Loading Interface' state. I tried INITIALIZE and then a reload, same

FINALLY!... From my case: " Apple has released the latest version of Crestron Go which addresses the crashes associated with the rotation issues on later versions of iOS.? If the phones or tablets

Please ignore this thread. I pulled the plug and reinserted again, and then voila, everything works as expected! Sorry to bother you guys!

Hi all, we initially planned on using Cisco CBS350-series switches?as a switching backbone for Crestron NVX (being the "recommended follow-up" of the SG350X series for which Crestron's answer

Sorry, I need to take a step back. Previously I claimed that the socket connection was successful, I was actually wrong. I had an IP-ID TCP/IP set previously, thus the connection was successful. Now I

The first thing to check is make sure Standby Mode is set to Communication On. You'll find that under Menu:Extended:Standby Mode. I would also turn the projector on manually and see if you get

I was just trying to turn on/off my HT projector to no avail.... I was using Crestron Certified Ehternet Driver for the projector (Crestron Certified Display Ethernet 2.0 (cm)) I use the

Phil, Three things I found while working with Nucleus: 1 If you have not yet worked with the hardware, you will need to note the decoder output type. TRX and RXS decoders differ in the HDMI output