开云体育

First off, I am assuming you are using SIMPL and not Crestron Home. Like Phil said, when you load the PRO3 program, it will take care of the IP table in the PRO3. But you don't use the 127.0.0.1

Doesn?t work unfortunately - same issue. Really weird. Another approach i wanted to follow is just to hardcode the URL into the VTPro-project. I put an page on the project, then added the embedded

Don't do anything manual with the IP Table in the processor. The code will take care of that. Add the IP Table entries in your remote devices - have them point at the processor IP address or hostname

Hello all, I'm a complete newbie with zero experience with Crestron products. I managed to crawl my way through P101 and 201 courses and was instructed to not go to 301 or masters without some real

On Thu, Feb 16, 2023 at 03:54 PM, <fujiakai@...> wrote: if you have the unit, test with with Putty from you laptop. the unit i have works on TCP port 23. This reply is for Fuiakai. Is your

It’s been a while but I’m pretty sure there’s a “home page” serial which you can call the desired URL which won’t instantiate another tab Tim Greenbank Control Systems Engineer

Thanks Jay, but it was a false alarm. 30 seconds after I sent that post, the technician called and said they figured out the problem. There was a serial adapter plugged into the Grafik Eye, that they

Tony, There are some Grafik Eye codes on Remote Central that might work for you if someone doesn't have a ready made driver. https://www.remotecentral.com/cgi-bin/codes/lutron/ Hope this helps Jay

receiving "FF" might be an indication for a wrong baud rate, maybe try different ones. BTW: you mentioned CEC control earlier, any luck with that? Do you have something like a DM receiver that can

Hi, i?d like to have a DGE100 just display a single webpage. I?ve designed a VTPro project consisting of just a single page with a browser embedded app in it. I?m feeding the desired URL into the

Hello crestronfreak55 I have also tried with this module, but without any result, I send the commands through the module and the monitor answers me FF without making any changes. I'm starting to think

Is there a way to group lighting loads so that D3 shows a single group vs individual loads? Essentially hiding the individual loads and only showing the group for adding to scenes and button presses?

The barco is just the conferencing system running on multiple Intel nucs. (barco nodes) All linked to one another via network.? Nucs all use a Linux back end with the Barco software up front. You use

Steve, Thank you for following up and supplying the documentation you have. Somfy did respond to me and they also said the high voltage relay interfaces are ESI RP60AU devices.? Based on the

What kind of a display technology does this Barco system use?

I'm currenty working with tech support on the rest API. So far they are not able to switch inputs.

The 4kz api is here: https://sdkcon78221.crestron.com/sdk/HD-MDNXM-4KZ-E_REST_API/Content/Topics/Home.htm

Are you working with a 4KZ switcher or a 4k? On the 4kz, the top has been shutdown by the engineers because of security flaws. The "conf output 1 route 1" command works on the 4k but not 4kz. Extron

Wait so you have the protocol to control that switcher without needing a Crestron controller? Would you mind sharing? Cheers Natalie

if you have the unit, test with with Putty from you laptop. the unit i have works on TCP port 23.