开云体育

? Hi Thorsten. Did you use a pre made module for ADCP or did you make your own ? Andrew

Not sure what ADCP is, but I'm using the Crestron 'Sony VPL-VW1000 v1.0' serial module

Hi Thorsten. Did you use a pre made module for ADCP or did you make your own ? Andrew

I've never been impressed with any Sony control but use the Crestron Connected module with VPL series and not had any long term issues.

It could be the polling...

Hi, i?m currently having issues with a GTZ380 and IP control at a client?s residence. I was using the Sony VPL-VW1000 v1.0 successfully with the VW790 he had before, but with the new projector

Second to that some switches have error threasholds crc wise and will disable a port, you could be triggering a storm control mechanism, A stretch, something flaky, turn poe off on the port if its not

That’s a fair point. If the same setup elsewhere is not having the network up and down issues then I would be suspicious of the networking side of things. Either an issue with a switch or Ethernet

I meant from previous network experience the switch port link speed negotiation between 10/100/1000... nic flapping, hence the up down state.... basic switch troubleshooting but it needs to be

gbnet, Though I have had good experience with IP control of Sony products, I pivoted back to RS232 for many things, as IP was getting a lot of noise, specifically with Smart TVs and their crappy apps

Dare i ask if your flapping behavior happens autonegotiate synch wise something happening at the net level / forced link speed. Some sort of interference based flapping.

I haven’t seen this on my projector ( a 550es which is the same as American 675es) but I use IP only. Just curious why you use both rs232 and IP. For me the IP control has been rock solid with this

Hi All, I have a site with this projector, controlled via RS-232 thru a DM-RMC-4KZ-100-C room box (50' from the rack). It's been installed for about a couple years... Though I do not remember having

For people searching this topic in the future, also verify you don't have Secure Only for connections.? If this is on you can't even get slot to slot connections to work.? Was setting up a new VM

ok, Thank you very much!! It's been a long week and my brain is fried. Have a good Christmas

Don't think you need to add it. Just add your rmc's under the Ethernet and then set your ip table on the rmc's. The DA just needs to be on the same vlan as your controller. Thanks, Ephrain

Does anyone know how to add a DM-DA4-4K-C to a Simpl program? It doesn't show up in the "Select a new device" window when I try to add it to my program. Tru Blu Support is closed today December 23rd

The following files and folders have been uploaded to the Files area of the [email protected] group. * /SonyAVRWebAPILibrary.clz ( /g/crestron/files/SonyAVRWebAPILibrary.clz ) *By:*

Nope, sorry! The archive has the old CLZ. I just posted the new (updated for NewtonSoft) CLZ in the files section. Search for ' SonyAVRWebAPILibrary.clz' (

It sounds like you need to enable the non-secure port in the panel.