开云体育

Has anyone figured out how to control the VOIP dialer of a BSS BLU-103?? There doesn't seem to be a module for it and I can't find published protocol for it either. TIA, Steve

Hi all Anybody knows if there is a driver to be found anywhere for JVC RS1000/2000/3000 or NX5, NX7, NX9 projector? Kind regards, Claus

?Hi Mitch If the room box is connected directly to a tv and the source is configure for 5.1 or anything other than stereo will the 351 down mix to a stereo while still allowing the 5.1 to be

Dear, In VT Pro you can select Crestron GO and design your GUI there, also in Simple windows configuration model kindly select the Crestron go as the touch panel on the Ethernet expansion. wrote:

Thanks Jason!

The VTPro type for CrestronGo is "Crestron App" wrote:

Hi All, apologies for the really basic question, but what panel type do I select in VT Pro if I'm programming a mobile project (iPhone) and using the Crestron Go app on the device? Its been a while

Didn't see it mentioned, but using a DMM with a diode check mode will help with determining polarity as well as issues with the emitter.? If you have a blink style emitter you can use a battery or

Looking at the comparison.? The 351 list Multi Channel pass thru or 2 Channel and doesn't have Digital Audio over HDMI?? Does this mean that you have to setup one or the other and can't have both

Hi guys is there a way to get the Apple TV home button to work with IR module ? To open up the Apple TV app ? Please advice Thanks , Mingo

Try this: rtsp://user:[email protected]:554/cam/realmonitor?channel=1&subtype=2 Replace user and pass with the camera credentials (make sure that user has stream permissions). The last number, 2, is

Steve, Yes. I've seen the issue before. It's something to do with the curly braces being escape/special characters in C#. eg. Console.WriteLine("My Integer Is {0}, My Second Integer is {1}",

I tested a motor with a similar string (different node id) and it works fine from an RMC3,? double-check the node id. Otherwise, I am not sure why it is not working. Make sure in your com port there

Found it, but you're right, there is some risk involved. Since its mostly dead already I don't have much to lose however shopping for a replacement might be a better use of my time. :-)

No delimiter, by delimiter you mean in the COM port definition where TX/RX goes right? 4800, 8, 1, O is correct, RS485, None for handshaking. From: <[email protected]> on behalf of Michael

Looks correct to me, also you have no delimiter correct? 4800 8 1 O for settings correct?

Inside, hidden under a small board. But based on question, I think that would not be a good idea to open it without knowledge about what you’re doing. Enviado do meu iPhone

Haven't done that yet. I'm attempting it now. Thank you!

Tried that, thanks! No change.

Where does the SD card plug in? Somewhere inside? I don't see a place for one on the outside.