开云体育

So, have you tried dumping the long integer straight into makestring using %lx or maybe %4lx something like MakeString(Output$, "ABC\x00\x00%4lx\x0D", number); From:

Is there any delimiter for the incoming string? Is the only content of the string a character representing a hexadecimal value (0-9, a-f), and is the case always the same or mixed? From:

Don't you need the ID to get feedback? Or is that no longer the case? Crestron@... wrote:

Also, I assume you have access to Toolbox, is that correct? Sent: Monday, December 31, 2018 3:40 PM To: Crestron@... Subject: [Crestron] Re: Tesla Vehicle Control Kit I have 2 powerwalls

I might be able to play around a little bit with something in my spare time, and toss something your direction to test with. Are you working with a series 3 processor? Sent: Monday, December 31, 2018

Hi All, Does anyone happen to have the serial commands for the ELMO PX-10? Googled every which way I can think of... TIA.

Hey there, Haven't worked on an HDX in a long while. Using the HDX-9000 v3.5 module. The GET_ADDRESSBOOKS_BUSY signal goes high and stays high. Any experience with this issue? Using an RMC3 and most

Hi All, I too have been wondering the same thing since the TSR-310 came out. Anyways, I finally called Crestron, here is their scripted response...... "Customers are curious about seamless swiping

we are experiencing an issue by where there is a meeting that will appear with "No Title" there is no rhyme or reason at to why this title has no information. If I go to the touch 10 the meeting has a

Thanks for the follow-up! Any configs you can send would be appreciated. Currently, I am wrestling with a SG350 in our lab. We have a few installations where we have Dante installations where our

The below is what I immediately thought when I read you post, I have not tested it (just taking a break from working and saw this). To anticipate the short values you can start from the end of

Unless you're daisy chaining the control of displays to several displays, there is no reason to use the ID. The MDC protocol allows you to use "0" to talk to all displays.

I have 2 powerwalls installed at my home. Let me know if you need someone to test any code for the powerwalls.

I have two Tesla powerwalls installed and running at my house. Let me know if you need somebody to test anything with the powerwalls.

i can't find the updated module in files... mark

Interesting that this thread would pop up again right after I just dealt with the same thing on a project that is currently in progress. I configured an isolated network with three Cisco SG-350X

I too have seen I can change the RTSP/MJPEG analog join on the fly or hard code it in VTPro with either option and my video streams play regardless of what its set to.

No, I didn't!

Were you able to find one yet?

Sorry I meant 27. Not 127