开云体育

Just sent this from debugger and it worked. Found the command on remote central to try in a browser. I inserted it into what I had from the Simple commands from the Roku I did. POST and

Hi All, I am, as a learning experience, messing around with IP control. I recently got control of my Roku to control and direct launch etc... Now I'm working with my Raspberry Pi with Kodi installed

FYI I have noticed that TSW panels seem to like the H.264H High Profile vs H.264 Standard Profile as well. Sent: Thursday, February 23, 2017 11:16 AM To: Crestron@... Subject: Re:

We have Ubiquiti Unifi system that works well. But it sometimes exhibits the same delays. It does not do mjpeg. I have mine set to h264 and 15fps via rest. 640x360 Here is a Crestron document I

Just curious what their UPLOAD side is. Just checked my clients settings. Sub stream is D1 (704x480) 15 FPS 1280 Bit Rate. H.264H. Takes 2 Seconds to pop up. My clients updside is 25M Make sure your

We're apparently among the first 'publicly' to attempt to register a Polycom Group series to O365 (cloud-based Skype for Business). This feature isn't even supported by MS yet, only through a special

Using the volume in these things can be done but I would echo some of the other comments. Modify the module and if you need. Do you need 100 true steps or increment of say 2, 3.? Sharp has newer

thanks for response. i can say on this particular install we are down to 320 by 240 and a frame rate of 10 by 128 kbps, well below the recommended settings and it still takes 20 seconds remotely.

?What's XY? I have C code for HSV2RGB that has worked well for me. Crestron@...> wrote:

Hello all, just updating everyone here. I've chosen a few people to test out the module they've received it and when I have feedback I will let users know where to get the module. If theres anyone out

Use a CF reader attach to your PC and in SIMPL Windows, under File, use 'Copy Output to Removable Media' :-). Hope this helps AD

Perhaps they had leftover RS232 chipsets from their old projectors that were notorious for having full buffers. Anybody else remember that? Crestron@...> wrote:

"Just a heads up, be prepared to do a power cycle every once in a while to bring the monitor back from the dead. FW updates, service menu resets, nothing works but pulling the power out of the wall

Thanks Steve and Logantv, Logantv, are you using a canned module with polling for settings or are you just sending commands? Do you think it would make any difference if you were only sending

there is a module in the application marketplace but also biamp has a command string calculator if you need it: http://support.biamp.com/Audia-Nexia/Control/Audia-Nexia_command_string_calculator

Did you check the Crestron Application market? Crestron@...> wrote:

Hai All, If any one having Biamp Audia Flex RS232 module please send to me, thanks in advance. Regards, Neeraj

Sounds like your stream resolution is to high. I wrote a module mainly for ICR that will call for the secondary stream when panel indicates that it is remote as well as allowing for different port

You can do that through an ICRealtime NVR

For those who don't know, there already IS a slack group with a good crew of people there helping each other out. we have around 141 members currently after starting it up around July of 2016. You can