开云体育

Tim, thanks for the input.? For some reason I've always been a little shy of Shars but it seems the quality is pretty good.? I have noticed the sell a TIR of 0.003" line and then a TIR 0.0012"

I purchased a couple of used 3-jaws from EBay over the past few years. They have been okay. One was pretty tight but others are now in the corner or on some fixture. The new Asian chucks have been

Thank you very much John. I will check with them. Jay Greer Yacht Design

Any thought to using a treadmill motor or similar AC/DC motor Loads of torque. I picked one up with the control board at the local scrapper. The pulleys take up a lot of space.

Good Morning, so the lathe I am putting together did not come with the original counter shaft assembly. The previous owner tried to make a motor mount / counter shaft assembly and jerry rigged

I made mine 25 or so years ago and do odd jobs almost weekly on the lathe with no problems. Dallas

Couple little case-hardened plates for the milling vise. In a pinch I expect could do without the case hardening. 2.5x7/8x0.25" and the same but 3/8 thick with crossed vee grooves for round stock.

Oh that stinks.? I lost my set screw on the threaded collar at the back of the lathe spindle.? I saw it fall and cant find it anywhere.Looks like your milling attachment is useless now, so I could

Curious why dont you just make your own.. -Sam

What do you need?Sent from my T-Mobile 4G LTE Device

Can't help from here but that sucks!As far as trash cans go in my "nest", wife won't touch it no matter how full!Might have a comment though.?Dave?Sent from my T-Mobile 4G LTE Device

The lathe Altas Craftsman lathe I got recently had the milling attachments but no plates. I ordered a set from Clausing. I think it was a decent price, shipping was reasonable and they arrived fairly

For re-mounting the chuck you don’t really have to remember which jaw was where so long as we are talking one of the Atlas lathes because they all have single-start threaded spindles. I guess that a

I did a bad thing the other day. I was cleaning up my bench and dropped the jaw plates for my 618 Atlas lathe milling attachment in the trash bucket and promptly forgot to go for them as soon as I

Should have added this: Heat longer keeping hardening material present and you’ll have hardness at depth. The hotter and the longer time the deeper and harder the case will be. Be careful with thin

My understanding is that Buck Chucks have a sort of 4 jaw type adjustment that would have a positive hold on the position of the chuck. If you are leaving room for movement and expecting the mounting

McMaster Carr has a big selection of brass screws in different flavors.?Soft tip as well.Dave?Sent from my T-Mobile 4G LTE Device

Not the chuck itself, just the mounting.?Centering is like a 4 jaw with left hand screws.No problem after you go the wrong way a couple times ;<)Dave?Sent from my T-Mobile 4G LTE Device

I had read about a guy doing that on line somewhere , was too late for the 6" chuck , but I plan to do that with my next chuck ??? ??? animal

Isn't that EXACTLY what I said?