开云体育

Kurt, I looked in CDCO, cdcotools.com, but I cannot copy a link to the post and tool holders because the page I am looking at doesn't have a link to it. However, it is item #29461 and includes the

Did you request a replacement part? Sent from my Boost Mobile Phone.

when ya go to buy extra holders , get the #2 & not the plane #1 , the #2 allows square & round tools along with some boring bars . & ya can turn the knurler bout face & use that for a square tool

Short answer is “yes”. A 3MT dead center will work fine in the spindle. Robert Downs Sent: Wednesday, February 6, 2019 14:46 To: [email protected] Subject: [atlas-craftsman IO] Dead Center

OK. That does save time and hassle to remove, rotate and press back on the gear. Robert Downs Sent: Wednesday, February 6, 2019 12:39 To: [email protected] Subject: Re: [atlas-craftsman IO]

Speedoo51: I had considered that the actual threads in the brass were not accurate to the size of the half nuts. Yes, when I was reworking my lathe I replaced my lead screw with less worn acme

Thank you all for responding. This helps a lot. Stan

I concur , best to get rid of as many variables that ya can ??? ??? animal

Stan, I would go with a #3, why compound the errors? Sent: Wednesday, February 6, 2019 3:46 PM To: [email protected] Subject: [atlas-craftsman IO] Dead Center The manual for my Atlas 10" says

The manual for my Atlas 10" says a sleeve is provided to go from a #2 Morse taper to a #3 Morse taper. I know little about machining and so I don't know if this means I could buy a #3 Morse dead

Agree with Kurt. I have one as well.? For the price at CDCO, it is hard to beat.? Pretty good quality, especially at that price.-Jody

Second that AXA recommendation from CDCO Tools. ________________________________ Sent: Wednesday, February 6, 2019 3:26 PM To: [email protected] Subject: Re: [atlas-craftsman IO] Quick Change

I would go with an AXA. I bought mine from CDCO (Bostar) and it has worked out well. Kurt S. Sent: Wednesday, February 6, 2019 3:24 PM To: [email protected] Subject: [atlas-craftsman IO] Quick

I have the Atlas 10" lathe. I do not know what the center to center is, but the bed length the carriage rides on is almost 36" from where it meets the headstock to the end of the bed. In this group it

This is called “zinc pest” and is the result of the casting alloy (primarily zinc) having lead as an impurity. ’Tain’t s’posed to be any lead in there, but has been known to happen. In other

Spacer is to line up the marks on the threading dial, most often marks get out of alignment when parts are mixed from different machines..

I have heard/read about that happenin with Zamak ??? animal

Hi Bill, Not taking sides on this one , but in my personal experience the Zamak parts do seem to vary in terms of longevity . Some years ago I imported the slotted shaft which operates the half nuts

I used a spacer to make the lines on the thread dial assembly line up correctly after installing new half nuts from Clausing. Regards, Rex [email protected]> wrote:

Other than the obvious, what is the purpose of the spacer? Or when would you need to use it? Robert Downs Sent: Tuesday, February 5, 2019 19:16 To: [email protected] Subject: Re: