开云体育

-- This email has been checked for viruses by AVG antivirus software. www.avg.com

does that mean i need to make a new email addy that contains both?? DG9BFC SIGI Am 07.02.2025 um 03:06 schrieb Group Moderator:

On March 2nd 2025, anyone who doesn't have their *FULL NAME* and *CALLSIGN* in the display name field on groups.io will be removed from the group. and IF your message delivery is listed as only "no

Hi Richard, This is the data I have. I’ll look for some more if I can remember. 73 Harley Burton N5BFB Sent: Saturday, February 3, 2024 4:54 AM To:

Thanks Chris, I am aware of the diff between RS232 and TTL, if you have a chance please look in the support section of my website WWW.VE2DX.COM ( /g/YaesuTuner/message/WWW.VE2DX.COM )

The RS-232 connector presents the same information except it's not TTL. TTL stands for transistor-transistor logic and has generally referred to using 5 volt logic levels. Most ham radio

Hey guys, here is some history to help understand my need; in the ft8X7 and ft100 radios Yaesu was offering a mini din 8 pin connector that had 3 functions, CAT TTL, TUNER, LINEAR, through simple

Thanks, that will certainly help. Harley N5BFB 73 Sent: 23 May, 2021 11:06 AM To: [email protected] Subject: Re: [YaesuTuner] Help! My FC-40 has failed The band data signal is the

The band data signal is the same for the FT-450D and FT-991A. I recently built a cable for my yaesu rigs that is working. The band select table is listed at the top-right of the diagram. Note that the

My FC-40 has failed to tune my long wire properly after working flawlessly for the last 4-5 years.? I did some more extensive testing and found this unique result.? It tunes properly on all bands

I use mine with a 66' radiator and about a 30' counterpoise and no ground, hb

My FC-40 needs a longer radiating element than the specs suggest. But I like to work on the 80 meter range. JD Vancouver Is VA7 BTL

Have not used nor do I own it but from some reviews it has a limited range (one quoted 3:1) so if this is true anything far out of resonance will be a no go with this tuner. Not necessarily a bad

Anyone use the FC-50 tuner yet? I have an FT-891 and the FC-50 tuner. I am still working on antennas and the the General class license, so I have not tested anything yet. Just checking in to learn

Will be very interesting. The fc40 does a good job if the antenna is complemented with a unun/balun.

Thanks Jerry. It looks like the fc20 and fc40 use different wiring too! I think that the key information that I'm looking for is how the tuning command is initiated. It seems that the fc20 is the

Probably of no help, I have the FC40 ATU the schematic shows all the signal wires going directly to the main processor. The pins are tx inhibit, reset, sense, data in/out, gnd, tx gnd and 13.5 v.

Interested in following this up. (I have asked the same question on the FT100 forum/s) Short answer - I haven't found anyone. Longer answer …. Clearly, the antenna tune mechanism is fundamentally

Build a fan dipole (several parallel dipoles each for a specific band) Then your internal tuner could tune that with ease Autotuner like fc40, sgc (xxx), and some other can easy be used for tuning

I decided to go ahead and get the radio to see what could be accomplished with the internal ATU. I installed a 2 band dipole (10M and 20M) and the radio will only autotune on those 2 bands so I'll