开云体育

I found the answer, the wires was active. AAAAgh ________________________________ Sent: Tuesday, April 13, 2021 12:00 AM To: [email protected] <[email protected]> Subject:

Was the “A12” indicator always flashing? If not, what should I look for? aprs.fi shows functioning NFM mode selected

I have a VX-8R and without looking at my manual, I believe that indicates that APRS is set to 1200 baud. DA1VF Floyd

I bought an FT-60R and was disappointed to find that it doesn't meet its spec for coverage in the 900 MHz band.? Tuning upwards, it skips 918.5-943.5 MHz.? I can't access these frequencies from the

Hello Group: Does anyone know what type of screw on the outside of the fnb-58li or fnb-80li battery is called??? What type of tool can be used to open the battery case? I recently obtained a

You need a precision tri-wing screwdriver set https://cpc.farnell.com/pro-s-kit/sd-081g/screwdriver-set-tri-wing-4pc/dp/TL14532 John Earnshaw M0JFE aka Beanpole or 26TM915 Tel:- 07940815659 “Ride

Hi, I have my dad's vx7r ( now sk ) that sounds off frequency... its 144 deviation is set to 110. Iv tried turning it down to 90 but it seems that after a power back on the value is still on 110. V/M

Whenever you make a change you have to save it, usually by clicking the transmit button. I have recently been retraining myself on my old VX7 and it took a while to relearn this. And sometimes

My VX-8DR will not power up after a failed program upload. I added some frequencies and during the upload there evidently was some issue, no error on the radio and the software said the upload was

power on off button worn out- disasembled- not carbon like earlier yaesu hts- silver coating on the back of power button almost gone. tested resistance across button- very spoty and iffy. clean board

Hello folks, Has anyone in this group installed the BU-1 or BU-2 BlueTooth module and gotten it to work? Then does anyone have it working with a generic BT earpiece or headset, such as a Plantronics

Probably a dumb question, so apologize, but did you turn on the Bluetooth in the vx8r's menu??

More... I even had it working, receive only, with my hearing aids Bluetooth adapter.

I only found ONE place to turn BT on, it this it?? See image :POWR: ON in the BT Menu. OK, so it worked with your hearing aid, meaning that it works with third party BT devices, that's very

It has been several years since I used my VX-7R, and when I turned it on the AUDIO was very "thin" (no bass component) compared to my VX-8R and VX-2R handhelds. Is this a feature of the VX-7R, or is

*Hi Gordon, If it works OK on wide FM (88 to 108 Mhz) it is likely the filter sold as eBay item* 171828786666. The Kenwood TS-2000 has a similar problem with the original filters failing. 73 Roger

Thanks Roger Another ham has diagnsed the same problemas probably the filter, maybe the speaker Gordon VE3JSJ

Easiest test for the speaker would be to use the VX-7 to listen to the FM broadcast band (88 to 108 Mhz). The FM broadcast band uses a different filter than narrow band Ham FM. Sent: Thursday,

Does anyone know if Yaesu plans to reintroduce the VX-8DR?? I understand new VX-6R radios are available new from time to time.? I owned a VX-8DR and would like to find another one either new or used

I have ill probably sell ... my wife uses it from time to time ... Has gps module in microphone and I think a headset ... It was my dad's bought new ... he is SK now.