开云体育

Is the radio on AM or SSB? Just thinking that might make a difference. Maybe not 12kc's but...Mike

Bruce, is this a FT 101zd? IIRC, I had to net the reference crystal in the counter module in my zd. I think it is accessible through a little hole in the top of the counter case after you lift the

Thanks Geoffrey but that page speaks to the skirt vernier dial.? My problem lies with the main frequency dial just above. Bruce

Mike, the main dial shows I'm at 14.048 when I inject a 14.060 Hz signal from my Elecraft XG2 receiver test oscillator. Bruce

Page 9 in the manual FT-101E, EE, EX Instruction Manual.pdf (iw2nmx.it) <http://www.iw2nmx.it/Yaesu/FT-101/FT-101E,%20EE,%20EX%20Instruction%20Manual.pdf> CheersVK5JB Sent: Saturday, 28

How many kc's is it off?Mike

Please advise how to align the main frequency dial with the actual frequency being used.? I'm referring to the top lighted dial.? I recall seeing somewhere that there is an adjustment (pot?) which

Update:Naturally...right after I posted this thread, I went back in and did some snooping.Took out relay RL-1 for examination under a microscope and found many of the contacts welded shut and/or very

You can view my ratings as a trader on the feedback forum in the classified advertisement section of qth.com. ?-- 73 de Carl N8VZ

You're probably right Bruce.

Hello group, My 101EE has taken ill and I need your help with troubleshooting. I'll try to lay out the events chronologically in order to explain what's going on. * Unit was used primarily on 80m

Did Yaesu ever make a matching antenna tuner for the FT-101 series transceiver?

I wonder if the tube shield would just hit the ant loading capacitor shaft. ?

Thanks everyone for all your input!I will leave it as is.Regards...MikeKD7VRG

To shield the bottom portion of the tube. This was not an uncommon practice. 73 -Jim NU0C "Tony VA7TF, VE7ACF" <20junk20@...> wrote:

I wouldn't put a shield over the 12BY7 as they run very hot as is. I suspect that the designers found that they got the required amount of shielding required with just the lower part of the tube

Hi Mike, No need to get a shield. Both of my FT101s came with a tube base that could take a shield, but neither one came with a shield. If you had a shield that would fit in your junk box, I don’t

All the FT-101 series I have owned and still own, there was never a shield covering the 12BY7. Unknown why Yaesu used that type of socket. Regards, Tony VA7TF VE7ACF. Sent: December

Hello again group, On my FT-101EE, I see that the tube socket for the 12BY7 driver tube is designed for a bayonet type metal shield. Is this factory design? or did someone in the past modify??

Hi Roger, I dont think it is/was for the speech processor. My EE came pre wired for the user to install an SP if desired. All my SP wires are brought up to where the board would be