开云体育

Sotars, what version of the DR5000 software were you on. The very last release from Digikijs make this way better.

Hi,? just about to carry out the YD9401 update (thanks James and DCC Train Automation).? I just need to have a clarification.? The manual for the YD7001 states in section 1.3 (2) that a ground

Thank you rzwartus for the heads up on the small stock in the Netherlands. I ordered one on Sunday for my 2nd DR5000 and it arrived today in the UK. Andrew

All, I have the V1 version which I suspect has a lot less functionlity of the V2 in the manual above. Being a total novice with this and not understanding the basic premise I am a bit stumped. So I

I would go B-Bus, then CDE – I didn’t think you get Xpressnet for connecting boosters and not with a YD7001 Iain Morrison https://wimorrison.com Sent: 21 March 2024 19:58 To:

Here's a diagram of my system. As I start to remove modules from the far end it gets more reliable. with only two left connected it works the first time as expected. I have changed the cables to rule

What my question is, as this booster provides multiple data connection's which is the better? B-bus, Xpressnet, or wired connectors?

wow, way cool.......thank you for the info.

Of course it did. That is because the problem originates in the DR4088LN, not in the command station !! Indifferent of the command station, Z21, IntelliBox, Digitrax, in fact any LocoNet command

Yes, if those are the options you want. Here's what you are doing. These are the physical dip switch that set options initially. We would flip the switches. 143 What have gone to the digital form of

Yes this problem has carried over from the DR5000 to the updated YD7001. ?I have a Digikeijs Loconet Digihub with connections to 3 groups of DR4088LN block detectors. ?On start up I simply unplug

I just updated my two DR5000's to YD7001. The DR5000 used to have this issue until Digikejs fixed it in the very last firmware release. Now the YD7001 has exactly the same problem. I have about 50

So if I understand right changing CV117 to 15 would make this one constant on at highest intensity.? If I wanted it to flash (bit 5) at maximum intensity, I would program CV117 to 47 (15+32)? Again,

Ok, I think that makes sense.? The pre-set will give a pulse to operate the switch and that is why I had so little trouble setting up?? If I assign a value I will change the light with the effect as

Any current updates on the back order for the 6018 or do I just need to move on? Thanks…

You have to change the CV values for the output number/position. You can use the Pre-Set and then modify the individual output positions. * CV?? Output?? Total * 113? ? ? ? ? 1??? ?

I agree 100%. ?It seems clear that you can do it, but a simple chart would be helpful. ?Honestly it would be great if there were one cv number for each or pair of outputs where you could control

Aha... * While operating the TCS, the DT602 does not update: That's weird. When both have the same Loco selected, they should be syncronous. * but if I pick up the TCS handset after previously using

I'm struggling to configure a YD7403 via the config tools, I'm using the latest build of the software but when I try to change the CVs to turn the booster on/off nothing is saved after clicking the

Thanks Karst. When will the manual for the YD 6016 RB CS be available in English. joh