开云体育

?While operating the TCS, the DT602 does not update. It's not a massive problem, but if I pick up the TCS handset after previously using the DT602 (and it's still left plugged in), the DT602 seems to "refresh" and then sends it's update over to the TCS. This can result in the loco stopping or a function turning off or on depending on how the DT602 was left.

Aha...

1. While operating the TCS, the DT602 does not update:?
   That's weird. When both have the same Loco selected, they should be syncronous.
2. ?but if I pick up the TCS handset after previously using the DT602 (and it's still left plugged in), the DT602 seems to "refresh" and then sends it's update over to the TCS.?
   That is very probably because the DT602 did not release the Loco. The TCS then effectively "steals" the loco. Which means the DT602 does what a LocoNet throttle has yo do: It sends it's last state every 30 seconds or so... :(
   
   

So please try again, but the releasing the Loco on the DT602 before picking it up with the TCS

Case 1. I will check ;)?

Greets,

Karst