开云体育

Thank you Iain for your advice. Do you think the YD8116 could drive two MP10s on a crossover from the same output? Regards Philip

Philip The MP6 is like the rest of the MPx range and you put a constant feed into the terminals, the cams inside the motor cut off the power when it has reached the limit. The MP10 Tortoise

Hi I am building my new layout using Yamorc decoders and MTB turnout motors. I have successfully set up a YD8116 to control a MP10 motor, using the standard simple definition for turnouts (device id

Colin, At this German Forum, there are people using the YD7010 for 0-gauge. spur0forum.de (

Ok, I'll give it a try. Thank you so much. Mario

Do a continuity test between the supply ground and both outputs, if there is none it should be ok. Mike

So it's no good? Do I have to look for one that has that double insulation? Thank you very much. Mario

If you live in Europe the output should isolated from the input ground, not all SMPSs are. If it had the double insulated symbol (square in square) then it definitely would be. Mike

Good afternoon everyone, just wondering if anyone has had any experience operating and programming O gauge loco's and decoder's using the YaMoRC system?

I have added the picture of the SMPS I am using.

I think I have succeeded. I have used the diodes in antiparallel and lowered the output voltage. Best regards, Mario

Good morning. The one I am using is the one in the photo. But I'm thinking of using the one in the first photo which is 19 volts and using some antiparallel capacitors to lower the voltage. But I'm

I found this on EBay and have bought several of these. They are well built and has the correct size connector. Would like to see more safety agency approvals. Comes with the power cord

Karst Whilst the OP called it a ‘transformer’ he showed a picture of a SMPS with a 19v DC output ? Many Thanks Iain Morrison https://wimorrison.com/ [email protected]> wrote:

You cannot use an AC transformer !!!

Ok, I will look for something as you indicate. I have one from the Roco Multimaus that I'm not using and I'll put it on the YD7001. Thank you very much for your help. Best regards, Mario

Mario The problem is that 18.4v you read could be higher or lower as normal multimeters cannot read a DCC signal accurately because it is not a 50/60Hz sine wave. I personally consider this to be

Good morning. I apologize for my English, I am using a translator from Spanish to English. I have put it on the YD7001 and the output voltage I get is 18.4v on the track. So, is it too high? Thank you

The SMPS will work with H0 locos, however the voltage is on the high side and I would not advise that the output is used directly. Sent: 15 October 2024 17:29 To:

Good afternoon. I'm going to move some HO locomotives I have but I don't have a transformer for it. I have got this transformer and I don't know if it will work for HO locomotives. I put a picture of