Hi
?
I am building my new layout using Yamorc decoders and MTB turnout motors.
?
I have successfully set up a YD8116 to control a MP10 motor, using the standard simple definition for turnouts (device id 3 or 4)
?
I also have some MP6 motors that only need a short pulse (1 sec) to drive them, as they are permanently powered.? Can the YD8116 be configured to control the MP6?
?
I see that the standard simple configuration for a point motor has a switch to "limit on time of outputs".? I cannot see anywhere to specify this time.? Could I set it to just 1 sec to create a pulse to throw the MP6?
?
Any advice, would be much appreciate.
?
Regards
Philip
