开云体育

Karst, I tried the update. Downloaded the file. Followed the install process. Then connected to the YD7001 and it connected fine. Then proceeded to update the firmware. I got multiple errors of

In other DR4088 types, the two common inputs are independent and thus so are the two input sides (if I understand correctly)? In the examples shown, Pins 1 to 8 would therefore have no connection to

Merry Christmas Karst. So appreciate all your hard work so that we can enjoy our play even more. Thank you. Cheers, Peter

No it cannot !! -GND units, including the YaMoRC versions, should *NOT !! be used on 2-rail* to do any detection connected to the track !! For current detection use the -CS variants. Still using

This is just an example of what you can use. Input pins 1-8 use the Left GND connection as common as shown. Inputs pins 9-16 use the Right GND. as shown Just make sure your devices you are

I have purchased some of these for sensor feedback (it's a two rail DCC layout) but just wanted to confirm my understanding of this diagram. In this example. * Are left side connections just a

Hello dear YaMoRC friends, *Build 68 is here ?* Just in time for under the Christmas tree ? . Both installers now have build 68 inside. What has changed: *1. YD_Config-build-68* - Support

Follow-up: I was able to re-establish connection with the DR5013 (see topic on how to force a firmware re-installation) and modify its settings according to Iain recommendations. Now i don't have

Following Karst suggestion I was able to re-establish connection with the DR 5013 Then I modified the settings as you recommended : 1) decreased the short circuit delay ( from 200 ms? to 50 ms in

How - what was the issue? Many Thanks Iain Morrison https://wimorrison.com/

Problem solved! Thanks

No, Only added bootloader LEDs in the YaMoRC products ;) When doing the Procedure as described, the LEDs stay all off. When holding the button and then plugging in the USB, you should hear the

Done,? but still no connection; still stuck in DEMO mode.! ? When I Hold the POL button should there be a change in the green /blue LED frequence ? Because nothing happens in my DR5013

Great Thanks Will do !

Press and Hold the Pol. Button on 5013. then Plug in USB and start the software. Gi directly to USB and click Update.

I'm having trouble getting my DR5013 out of DEMO mode. I tried with 3 different USB cables Even with the DR5013 connected to nothing else than the PC the? COM port shows? correctly on the device

If it still showing Demo Mode then it means you have not connected to the DR5013 to the computer. I recommend that you try another cable. Iain Morrison <https://wimorrison.com>

Got it installed? ! Cannot get DR5013 out of demo mode though :(

[email protected] | Files </g/Digikeijs/files> Iain Morrison <https://wimorrison.com> https://wimorrison.com Sent: 12 December 2023 12:37 To:

I had found the link with the manuals but not to one with the firmwares I’ll keep looking ! Thanks again!