开云体育

thankyou

Thanks a lot.

Good afternoon. I have in my case DR4088RB and DR4088. According to the image I have of the DR5000, it shows how to connect it and I imagine it will be the same on the YD7001-E. My doubt is that what

Hi, We have this one online: http://www.yamorc.de/downloads/YD7010.en.pdf It's for the new YD7010, but the contents are upto 99% the same ;)

Good morning. I return to this topic because there is something I must be doing wrong. I would like to connect the YD7001-E directly via LAN but it does not recognize it. Yes, it connects via WIFI and

As I have seen in the manual it indicates that it needs to be 13 volts. is that so? Thank you so much.

I have already obtained it in English and I have translated it into Spanish. Thank you anyway

I just ran the German version through a PDF German to English converter. A quick Google search for the conversion.

i just purchased a yd7001e from iron planet . thanks to this site informing that they had them in stock. is there and english version of the in structions in pdf?

Yes the splitters are all passive and you can fan out connections in as many directions as you have sockets on the splitter. Pete S is very sensible in his answer re cost. I like it! Patch cables are

I'd be pretty sure you can because all the connections are symetrical in the connector, and looped in the modules. The whole system is a common bus that serves all modules the same data at the same

This is a 16 page manual off the YaMoRC website. http://www.yamorc.de/downloads/YD7001-E.de.pdf -- Dennis Cherry Owner/Moderator

Good evening. Where can I get the manual in PDF format for the YD7001-E? I found it on the internet but it can't be downloaded and I would like to have it. I think it's about 50 pages. Thank you so

Hi I am currently using a Black Z21 with Loconet to connect 4 DR4088LN detection modules that are arranged in a U shape. ?The Z21 is physically located in the middle of the U and the cable goes up

Trying to remember how to turn on a Dt500D. New battery. When I hold the power switch it comes on says 9.5 volts, says idle and powers off. Jeremy Janzen, CTS

I just ordered a YD7001E from Iron Planet Hobbies. There are 6 left as of this moment. I have been waiting quite a while for this to become available. What is the YD7001E? It's a DR5000 that has had

Does the YD6016 need 14V? The above is for the YD7001. Wouldn't anything dropping voltage after the block detector trip the block detector? If the YD6016 doesn't work at lower voltages, how about a CT

I show you an image of what it looks like in a Marklin Station 2 box. In this case it is low from 12v to 10v so there are fewer diodes.

Gives this: But as said before, to use this ( more than 8 modules ) you *must*? set "First Contact in Feedback Space" to 0. This is the way it looks in "LocoNet Space" : If you would desire, You

what i mean by out of sink is if you open up the yd7001 software click on the exts88 and click on feedbacks follow the numbers down until you come to number128 the next number should be 129 but it