开云体育

... and to answer your 1st question... yes, I know it can be done, I'm just not clear on the approach to setting the CVs appropriately. There are YouTube videos on this topic but they all leave me

Thanks for asking this question. I, too, have asked this question in the past. I received replies but I am still left without a clear understanding of setting the CVs appropriately to have certain

Sorry Karst, my mistake and you're assumption was correct. While operating the TCS, the DT602 does not update. It's not a massive problem, but if I pick up the TCS handset after previously using the

yep, that‘s sad indeed. Unfortunately there is a lot of non-knowledge out there. better ask ?The Master“ himself ;) greets, karst

That‘s not a Problem !! as by design, the Roco-RBus does not allow for individual addresses. so please follow the manual to assign addresses. greets, karst

I have tried to change the Address numbers of the Input Properties on two of my YD 6016 RB Current Sensor but it won’t let me change the numbers in the Address column. It lets me change the numbers

H Karst, Well thank you for letting me know at least I can now leave it alone as it is and save everyone's time. The sad thing is several people had told me I was going to be able to do this, it is

Hi all, I have requested to become a YaMoRc dealer, I run a small DCC business in Australia, Buckambool Model Trains, predominantly dealing in decoders from ZIMO and ESU, plenty of installation work

My prodigy advance has locomotive, route, and accessory functions.? I have a Dr4018 that I am controlling my atlas smap switches.? Honestly 4 years after I set up I could not tell yyou how I did

Has anyone tried connecting decoderwerks booster yet? Can't seem to find much on the subject.

Hi, It looks to me that Doug is looking for the routing function of the DR5000... ( aka, connect to the WiFi and then gain access to the LAN network ) Well good news: That horrible security hole in

Hmm... an even more confusing statement ;)? ( since it's exactly the opposite of what I concluded ) Please try to elaborate what you are doing on either Throttle an what is/is not updated from which

Hmm strange.? Here's how it worked for me assuming I understand this is what you're after. On my recently upgraded YD7001 connected to jmri using USB cable from my laptop (where jmri will be

I have tried that already. when I turn off the Withrottle in the YD7100 the TCS reports it cannot find Withrottle at all. ?I tried setting the address and port manually but it still does not work

Been a long time since you could. Most countries including US, interest rates are higher and that impacts exchange rates. Unfortunately buying stuff from US isn't cheap and postage just adds. I

I bought one yesterday from the Netherlands. Still stock available there; https://www.n-spoorstore.nl/nl/yamorc-yd9401-netwerk-module-upgrade-dr5000-6091009842801 Regretfully postage is more than the

Yes, the dt602 does not update the TCS throttle, but it works the way around.

Hi, Can you describe a bit more elaborate what updates what and what does not ? Now I conclude that the DT602 is not updated while operating the TCS ?? Greets, Karst

If you don't want the TCS to connect to the WiThrottle service on the YD7001, then just turn that service off (assuming you don't need it for anything else). Then, when the TCS boots onto your

Hello everyone, I upgraded my DR5000 to YD7001 the other day and for the most part it went well and I'm up and running. I had a couple of niggles i.e. Dodgy USB cable, and I had to re-jig the S88