开云体育

John What did you do to sort it? [email protected]> wrote: Many Thanks Iain Morrison

Fixed!!? All now working well.? Thanks to you both for your help and advice. Regards, John

Thanks for the tip Iain , I will do that. Regards,? John

Hello Darshan Here is the UK reseller. https://www.dcctrainautomation.co.uk/yamorc-yd6016ln-cs-current-sensor.html Many Thanks James Hudson Director 01823 429309 https://www.dcctrainautomation.co.uk/

Thank you. So no use for the unit i have with me. I need to sell it on ebay i guess. Normally it says for 3 rail but this didn't have anything on it when i bought it that is where i got confuced. Very

You could use a YD6016LN-CS which will provide you exactly what you want. It is similar to the DR4088LN-CS, but with enhanced functionality and none of the faults ? Sent: Thursday, July 20, 2023

Have you switched off the LED using the DIP switch? This draws enough current when it is idle to cause the feedback to trip and show occupancy. These modules are not meant to cause the feedback to

Thanks Karst.? Will try that. Regards, John

So no use for me with this. I can see what is happening. Maybe it is working as just a connector and nothing else. I have attached the photo. If this is the case then i will remove this and join all

Thanks ! Have fun with the update. !

Pretty logical behaviour... The LoDi takes samples from the track power, that causes a current to flow. Hence it triggers the DR4088LN which has very sensitive inputs. How to solve: 1) Connect the

100% co-incidence ??? :D

Well... that is very unlikely. These feedback units are only suited for 3-rail M"arklin track. And not, *never* with a DR5000 ! Do you have a picture with how you exactly connected it to your tracks ?

Well.... it's common knowledge, that the Digikeijs produced V1.6.x versions are not the most stable ones... V1.5.5. is the last known stable.

Hi, Following on from the problem on my turntable with a DR5033 (almost certainly faulty and not auto reversing)??I bought a Lodi reverse module.? The reverse? module was tested on the turntable

Hi, I have a DCC layout. Without properly checking I have bought a starter kit?Digikeijs DR4088 GND (photos attached). Is there a way to use this on my 2 rail DCC system connecting to iTrain. This is

The funny thing is, I just happen to have one in the mail on the way here now. ? Ryan

I have used many of Dennis's videos with the DR5000 setup. Thank you very much. Question? Is there a reason one would want to downgrade? Does it fix a problem? Or is this video standalone as a how to

Good and clear Video.

The one has nothing to do with the other... YaMoRC is *NOT* (!!) Digikeijs....? Digikeijs was merely a licencee for production and wholesale of my designs ;) Just a customer of mine. Greets, Karst