开云体育

Hi I forgot to mention following: do not remove the strap from wheels until you have finished installed the bungees ( and have the wheels on the ground while installing ) Regards Bernhard -----

Thanks Bernhard and Michael. I will try that email and hope for the best. Now, onto another situation: Due to the fact a harsh Canadian winter is upon us, and I fly from a grass strip, where snow

Sorry but I screwed up the link to the first 3 documents http://gofile.me/5wcGE/0aaTnATQJ http://gofile.me/5wcGE/AHZGG7Q2X http://gofile.me/5wcGE/RCSPXxOp3 Michael Coates wrote on 21/11/2021 10:36 am:

Hi Try this mail: office.randkar@... I have been using this mail with success. They answer during working days ( not weekends) I ordered new bungee set which was priced about 80 Euros (mail cost

All of you gentlemen are extremely helpful. :) Excuse my ignorance (with all my novice questions), but this website is truly a great resource to not only network with other aviation enthusiasts, but

See answers in red Justin Gregoris wrote on 21/11/2021 9:58 am:

I have attached a picture of the email I tried multiple times and still no response. Moreover, on the Randkar France website, the bottom right-hand portion of the Hanuman page shows a yellow-boxed

Justin Gregoris wrote on 21/11/2021 6:10 am:

Hi Ok first what email are you using to contact Randkar in france. I ask as I strongly recommend to buy the bungee from xair. If you like I could perhabs help here to get you in contact with Randkar.

Thanks for the guidance. Are you able to show me a picture of your setup? What kind of strap do you use between the two landing gears? Is it the exact same bungee cord making model has the bungee cord

Hi Buy the original bungee from factory or dealer.I bought mine from Randkar the main dealer of xair aircraft in Eirope. I use strap between wheels to pull the wheels together - thigten the strap by

many thanks. I will look for 10mm total diameter bungee cords at about 5 feet long - giving a total of 4 pieces at 5 feet long each and 10mm diameter chord. Justin ________________________________

Yes weight has to be off wheels otherwise you cannot get enough stretch to do the the turns, you have to have a half turn so you end up with loop each end, I was referring to 4.5 half turns, I may be

Many thanks Steve! My recently purchased X Air Hanuman/Hawk is 2009; going on 13yrs old. It is red exterior but with only 146hrs on airframe and Jabiru 2200. The Dacron still looks good, I'm no expert

I did own a XairH called Hawk in UK. Very nice aircraft but I considered the main undercarraige to have poor geometry. I measured my old bungee at 1460mm x 10mm over the loops. It needs maximan

Good day everyone, Does anyone have specifications of make and model and size needed for each rear side of the bungee cord landing gear as well as installation instructions they can send me or

good catch michael! many thanks - i will pay attention to that as i decide what to do. if i close gaps during the cold, it will cause a hotter cabin in the summer months so i have to consider all

Just as a secondary comment, be careful closing all of the gaps. In one of the standard X-Air aircraft I had a customer in the early 2000's that closed all of the gaps and it ended up creating a

Justin: Unable Mansfield due to runway length and performance of my current plane. Collingwood best - but only when you are comfortable flying there. Keep in touch! Geoff Gartshore Zenith CH200 GCUD

Thanks for all the help Geoff. I think the seller gave me new bungee cords, but at any rate, it would be nice for you to see the plane in person so you can give me all the tips for safe, fun and