开云体育

?So the machine arrived yesterday. With the bobbin winder broken off near the base that attaches to the machine. Despite me putting in my usual plea to the seller to please make sure the machine is

Welcome to the group Libby!!

Hi Carolyn, Funny I was just having a discussion last month on the face book W&W group about hand cranks for W&W.? I never knew they made them.? Apparently a few?member of the fb group have several

Miller, Only the bandwheel on my 8 has two grooves. The handwheel has only one. I think there is a picture in my album that shows it, if not I can add one. Did W&W change this feature at some point? K

Welcome to the group Paul.? What a lovely collection you have (from your projects page), That Singer 29-4 Leather Patcher is gorgeous, and who knew the W&G parts aren't interchangeable.? Good to

Welcome to the group Ken.

Hi! Libby from Tennessee here. Just got my first Wheeler and Wilson. A No3. So glad to find some fellow enthusiasts. 6 kids, 22nd machines 5 of which are treadle and 1 hand crank. Got my kids raised

Hi Miller Yes, I think mine is a special case too. But not special enough to not be in that figure / picture from my last post.. The bobbin is definitely 22mm x 7.2mm and it definitly goes with the

Hi Bernt; It appears that what you have here is the old style bobbin drop with new style case having attached tension spring. I am now wondering if the bobbin dimensions were also changed at this

Hi Miller, group This Figure/picture here shows the other side of the case. It and the machine part with the wire like lever to unlock the case, look exactly like what I have here.

Hi Bernt; That picture from your manual is essentially identical to the one in my #9 manual. My #9 manual does show the case with the locating finger, but otherwise everything is just alike. What is

Hi Miller My bobbin and case and the spring look pretty much exactly like the manual shows it except that there is no slot as shown in the manual. Here is a picture from the manual:

Carolyn;I hate to be the bearer of Bad News, However;?A W&W 9 machine is not an easy machine to convert to handcrank. If you go to the photo section on page 9 I have submitted pictures of two

Hi Bernt;Not sure what I am seeing in the 2nd picture, the one of the spring. Some time back I posted pictures of the bobbins & cases normally encountered on the family W&W machines. They can be seen

Here is a link to the photos I have now managed to upload: /g/Wheeler_and_Wilson-Sewing-Machines/album?id=59359 Best regards Bernt

Hi all, I have been a vintage sewing machine addict for about 8 years (closing in on 90 machines at this point) but only joined this group recently before having acquired anything other than a Wheeler

Hi Miller, So nobody saw my pictures or did they end up somewhere? Mine is the 8 early 9 type. But: There is NO slot in the casing as in the manual and as you mentioned. It is thus not possible to get

Hi, I think it should perhaps be from the bottom towards the left not the right.? Maybe I am doing it wrong but that is how I understood the manual.? ?"To Place the Bobbin --... Let the ring be

Bernt;You can post pictures in the photo section of the groups main page. Any attachments to an E-Mail would simply stay with the email.?"Most" W&W #8 machines used a plain bobbin case without a

Where do the posted attachments/pictures end up? My previous reply had pictures of the problem spring and case.