Re: #8 Feed dog adjustment
|
Hi Vyrl. If you email me your mailing address, I'll send you a replacement set screw. My email is gracied27@.... Bill.
On Friday, May 22, 2020, 7:51:58 p.m. EDT, <vyrls@...> wrote:
I found my answer in the manual:
"To adjust the Feed -- Should the feed-bar be worn down by long use, it may be raised by turning the middle screw in the feed point, with the screw-driver on the small steel wrench. Turning to the right will raise, and to the left will lower the point."
It doesn't say what the correct height is.
I am missing the center screw in the feed dogs.? Where can I find this screw?
Could someone measure the screw and tell me the dimensions and thread pitch of this screw?
Thank you,
Vyrl
|
