Wheeler_and_Wilson-Sewing-Machines@groups.io

Vyrl All Messages By This Member #3843 How do you adjust the feed dogs?? What is the correct height? Thank you, Vyrl
Vyrl All Messages By This Member #3849 I found my answer in the manual: "To adjust the Feed -- Should the feed-bar be worn down by long use, it may be raised by turning the middle screw in the feed point, with the screw-driver on the small steel wrench. Turning to the right will raise, and to the left will lower the point." It doesn't say what the correct height is. I am missing the center screw in the feed dogs.? Where can I find this screw? Could someone measure the screw and tell me the dimensions and thread pitch of this screw? Thank you, Vyrl
Bill Morrow All Messages By This Member #3850 Hi Vyrl. If you email me your mailing address, I'll send you a replacement set screw. My email is gracied27@.... Bill. On Friday, May 22, 2020, 7:51:58 p.m. EDT, <vyrls@...> wrote: I found my answer in the manual: "To adjust the Feed -- Should the feed-bar be worn down by long use, it may be raised by turning the middle screw in the feed point, with the screw-driver on the small steel wrench. Turning to the right will raise, and to the left will lower the point." It doesn't say what the correct height is. I am missing the center screw in the feed dogs.? Where can I find this screw? Could someone measure the screw and tell me the dimensions and thread pitch of this screw? Thank you, Vyrl

开云体育