开云体育

What commands are available that I can send to a VARA port I see BWXXXX is accepted but that about a freq change or anything else or does that need to be done outside of the vara connection While I

I think he wants the antenna tuner to tune the antenna, not tune the drive audio. btw there is a tune button for audio drive in both VARA FM and VARA HF. Robert, in the Winlink Express VARA HF

Oops, I may be mistaken. I use tune on VARA FM. Not sure if that function exists on VARA HF. I’ll. Check tomorrow and reply then. I do use VARA HF regularly on 40m with

Yes, regularly on 40m. But sometimes on 20m. [email protected]> wrote:

Open VARA first, without Winlinkexpress. Select a station and go to the Tune screen.

I have done that many time in VARA with my 7300. Are you able to reach a station with VARA? [email protected]> wrote:

I have a ic-7300 and would like to be able to send a tune command to the radio after a freq change I can do it on BPQ in the forwarding script but I dont see a way to do it using winlink Express and

I have the optional TNC, however removed it years ago, as it is sub par as compared to a 'real' TNC. I don't recall whether the DB9 was plugged directly into the motherboard. I'll have to open it and

Gary, Have you opened the radio to see if it has the optional internal TNC installed? If so, remove the TNC and connect the 9pin directly to the motherboard. [email protected]> wrote:

Are they being used with mic/speaker audio, or the dedicated data port on the back? I used mic/speaker audio on my Mark II but could never realize high speeds with VARA-FM. As I recall, I resorted to

Shortly, I will start doing a series of screen caps every half-hour of my 30 and 40 meters APRS-over-VARA maps.? I will assemble these into an MP4 animated map showing propagation changes on these

Speaking for the ARES group in the Washington state capitol, Olympia/Thurston Co. I am very interested in the outcome here. Based on your report I will mod at least a couple of the radios used for

The Alinco DR-135 series are good radios for VARA RF Wide as it they have an analog unfiltered interface.? I have a number of these.? I was just made aware of a potential problem with the Mark 3

VARA and most modern protocols use a variety of modulation and coding schemes based on the current average S:N ratio. The math and coding/decoding are complex but the concept is simple: The higher

This particular one is wide. I connected to it one time with no issues but haven't been able to connect with it or any others? since. I tried to use the test mode in vara....the transmitter seems to

Thanks for your comments. I plan to build in a near future a QMX+ and when its firmware will implement CESSB I will be able to use Vara HF Winlink with it. This closes this thread. 73 - Pierre -

Well, now I feel like a complete idiot again! I got the new sound card in. It is called an AIOB (all-in-one-board) and it's actually like the AIOC, but has separate pads for the various I/O so it is

From the QDX website: "QDX is suitable only for _single tone FSK_ modes, which covers the majority of digital modes in use today. This includes everything in WSJT-X (except MSK144), JS8Call, some

I just tried the Kenwood TS480 setting with the same result: CAT PTT works but the audio level from the PC is not enough to put the QDX in transmission, I might miss an audio level setting in the Vara

I just looked up the exact specifications for VARA HF and there are multiple carriers even with FSK. The QDX can only transmit one tone or frequency at a time. Andrew VK5CV Get Outlook for