开云体育

This topic brought back memories from an unrelated area of my past. Years ago I was an avid home brewer and wine maker, and needed to recycle bottles with labels. I used a product called Straight-A

Off course you co

I only have a short minute but want to post this.? I will comment more on your other posts later when I have more time. All Tektronix documentation has the physical locations of C1115 and C1132

Hi Dieter, Thanks to Fabio's detailed and clever reasoning (you're very gifted Fabio), I have found the issue with the Alt mode. The problem turned out to be a defective U4391 (74LS02) that can be

C1132 10 ?F 160 ELCTLT 10 ?F 160 Nichicon PW I pulled out a 250uf 20v from this location C1115 250 ?F 20 ELCTLT 330 ?F 50 Panasonic EB I pulled out a 10uf 160v from this location I seem to

For C1120 10 ?F 100 ELCTLT --> 10 ?F 160 , Can I use https://www.digikey.com/products/en?keywords=493-11505-1-ND or is there some benefit to using a 160V cap?

Its mostly correct, but I found an error, maybe two. C1065 .056 ?F 250 MTLZD .056 ?F 300 Vishay Polyester Film 399-7635-ND The lead spacing is to wide for the replacement part. Should be 7.62mm but

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the [email protected] group. *File:* Hameg.zip *Uploaded By:* r221b@...

Upload it to the files section? Regards

Hello Ed, I used to have a Hameg 5005 which should be the same as your AT 5005. I have the service and operating manuals including schematics and alignment instructions. I'll be happy to send them to

I knew some on the Marshall, but drawing a blank where or when.

Just might have. I was 627 and 654 blue. Remember Franco and occasionally caught some marine or sailors drunk on the beach. A shot in the head was the punishment. I was in Scotland when there was a

Interesting: Our paths may have crossed ... Home was the GCM Blue so we went the same places. I was in Roto when Franco died my last deployment. Thanks for the welcome brother -- Joel

Ray KD9CCZ

Ok, 5 of the 10 are spoken for so far. thx Ancel

Should be: Hiroshima Diary by Michiko Hachiya M. D.

Yes, Hiroshima Diary by John Hersey M.D.

FWIW, the contents of brand name solvents like Ronsonol are in their MSDS available via the web. The MSDS also usually list the CAS numbers of the constituents. There are some tutorials on solvents on

And NO! I do not want to EVER see that terrible force be used again. We should never forget how terrible war is, not just these bombs, which took the lives of a very small percentage of the 50 Million

On Wed, Jun 13, 2018 at 11:35 am, EricJ wrote: > > I should hope that no one ever forgets about Hiroshima. Or Nagasaki. It would > seem difficult not to know about the places hit with the most deadly