The manual I have shows a Belden number. I looked for that as well but no luck.
Thanks,
Barry - N4BUQ
toggle quoted message
Show quoted text
----- Original Message -----
From: "Michael A. Terrell" <mike.terrell@...>
To: [email protected]
Sent: Wednesday, July 25, 2018 11:12:38 PM
Subject: Re: [TekScopes] Looking for Power Cord for 400-series Scope
Wasn't Tek using Belden power cords at that time?
Michael A. Terrell
-----Original Message-----
From: Phillip Potter <p.potter@...>
Sent: Jul 25, 2018 11:56 PM
To: [email protected]
Subject: Re: [TekScopes] Looking for Power Cord for 400-series Scope
I wish to add my two cents...
I purchased some power cord to replace the butched one on my 453 (w/
same wire specs) only to find that it was too big (overall size) to fit
the cable clamp on the scope! I was forced to whittle the outside sheath
down to get it to fit... I was not happy but did end up with a cord that
included a plug with a cord holder.? I learned my lesson; never
assume... I know, I know!
Phil
