Ren¨¦ Rajesh,
Thanks for the replies and pics. I thought that was correct but just wanted to make sure.
Thanks,
Barry - N4BUQ
toggle quoted message
Show quoted text
----- Original Message -----
From: "Barry" <n4buq@...>
To: [email protected]
Sent: Monday, July 23, 2018 9:28:03 PM
Subject: 465B - Power Switch Mounting Nut Question
A few months ago, I removed the trigger board from my 465B to work on the
power supply caps. I started reassembling it and was left with a small
nylon(?) block with a hex nut holder and a small slot in it. See the album
below for pictures of it.
/g/TekScopes/album?id=64907
If I'm not mistaken, I think this is used behind the nut that holds the power
switch in place and I used it that way (last picture); however, I'm
wondering if I have it turned 180-degrees and the small slot is supposed to
align with the main board.
Is that where that part goes and, if so, is it supposed to align with the
other PC board? I've found one picture on the web that shows it and I think
that's correct but would like to know whether I have that right.
Thanks,
Barry - N4BUQ
