开云体育

465B - Power Switch Mounting Nut Question

n4buq All Messages By This Member #149901 A few months ago, I removed the trigger board from my 465B to work on the power supply caps. I started reassembling it and was left with a small nylon(?) block with a hex nut holder and a small slot in it. See the album below for pictures of it. /g/TekScopes/album?id=64907 If I'm not mistaken, I think this is used behind the nut that holds the power switch in place and I used it that way (last picture); however, I'm wondering if I have it turned 180-degrees and the small slot is supposed to align with the main board. Is that where that part goes and, if so, is it supposed to align with the other PC board? I've found one picture on the web that shows it and I think that's correct but would like to know whether I have that right. Thanks, Barry - N4BUQ
tek_547 All Messages By This Member #149907 Edited Hi Barry, a few weeks ago I had to do the same (horrible) job of replacing the power supply caps in my 475A, same construction. And I also wondered why Tek used such a "distance" holder for the PCB to lock the nut. I mount it exactly as yours in the first picture and it?s sitting sturdy and fine. So if you mount it as picture 1 and it?s alligned with the other board it is OK. 搁别苍é
Rajesh VS All Messages By This Member #149911 Hey Barry, Ive added two pics from my 465 to your album, the Slit needs to align in to the PCB. /g/TekScopes/album?id=64907 hope it helps, regards Rajesh toggle quoted message Show quoted text On Mon, Jul 23, 2018 at 7:28 PM, n4buq <n4buq@...> wrote: A few months ago, I removed the trigger board from my 465B to work on the power supply caps. I started reassembling it and was left with a small nylon(?) block with a hex nut holder and a small slot in it. See the album below for pictures of it. /g/TekScopes/album?id=64907 If I'm not mistaken, I think this is used behind the nut that holds the power switch in place and I used it that way (last picture); however, I'm wondering if I have it turned 180-degrees and the small slot is supposed to align with the main board. Is that where that part goes and, if so, is it supposed to align with the other PC board? I've found one picture on the web that shows it and I think that's correct but would like to know whether I have that right. Thanks, Barry - N4BUQ -- /Rajesh
n4buq All Messages By This Member #149917 搁别苍é Rajesh, Thanks for the replies and pics. I thought that was correct but just wanted to make sure. Thanks, Barry - N4BUQ toggle quoted message Show quoted text ----- Original Message ----- From: "Barry" <n4buq@...> To: [email protected] Sent: Monday, July 23, 2018 9:28:03 PM Subject: 465B - Power Switch Mounting Nut Question A few months ago, I removed the trigger board from my 465B to work on the power supply caps. I started reassembling it and was left with a small nylon(?) block with a hex nut holder and a small slot in it. See the album below for pictures of it. /g/TekScopes/album?id=64907 If I'm not mistaken, I think this is used behind the nut that holds the power switch in place and I used it that way (last picture); however, I'm wondering if I have it turned 180-degrees and the small slot is supposed to align with the main board. Is that where that part goes and, if so, is it supposed to align with the other PC board? I've found one picture on the web that shows it and I think that's correct but would like to know whether I have that right. Thanks, Barry - N4BUQ

Previous Topic Next Topic