开云体育

Great photos and write up so far Warren thanks. I have a motorcycle jack too but I’m planning on using a lower profile appliance dolly under both the trans and motor. Sits quite a bit lower. If

Good point. However I have an 88 tintop automatic that I plan to make my townie bus so I might need the 2.1 for it (unless I come across another 2.5 sometime soon). -- Warren 89 Westy 88 Tintop 70

List the engine, harness ECU etc on theSamba for an outrageous price. Pepople still want that 2.1, 95 hp stuff.

You could always leave the intake manifold off the Subie for the install.

As you can see, I don’t have much room up top because my garage ceiling is only 8ft. ?But I’m confident it will work. ?I need the rear “valance” of the bus to be 28 inches above the floor in

I drained the oil as well. ?So after working everything from the top side, I jacked it up and put stands under each rear tire (front tires chocked). ?Tomorrow I plan to disconnect the CV axles,

So today I began work in earnest disconnecting everything that would need to be removed in order to lower the engine out. ?This included the power steering lines, vacuum hoses, coolant lines from the

Because I intend to remove the gas tank to install stainless coolant pipes and to do maintenance on the tank lines, I drove it around until it was way below the empty mark. ?I carried a gallon of gas

I pulled the bus into my garage and, mustering courage, started prepping it for the removal. ?I began by using my shop vac to suck all the coolant out of the system by vacuuming through the coolant

Okay, so I’ve started on the removal of the 2.1 from my Vanagon to make way for the Subie 2.5. Here’s a photo of a perfectly good running 2.1 that I have driven coast to coast several times.

Hi, I think M. Clymer is quite busy, you could talk to M. Curtis Reed, Email : seattletourguide@.... He is a good friend and associate of M. Clymer in 5Speedbus. By the way, their shifter kit

Eric- I have made this mistake myself. I burned up an alt doing this. LI batts pull too much power when charging for a starting batt. Todd's reply is correct-it can burn up your alt unless the batt

Hello Group, I am trying to contact David Clymer and my information must not be current. Can anyone help me to get in contact with him please?

It’s my understanding that a lithium battery will charge at much higher rates than a lead acid battery. It is able to do this because of a much lower internal resistance. It’s likely that your

I'm considering replacing my batteries with a 100 AH 12.6V LIFeP04. The few I examined thus far can support 100 A draw.? ?I hear the original starter drew 65A spinning the air-cooled engine.? ?

Great info guys, thank you. SeanG

Busaru on YouTube provides the Wiring Harness Series-#7 ECU Pinout link for several Subaru years.?

Your number indicates a 00-01 Impreza using Google. If from an auto trans, I think? you could comb the wreckers for another harness including 02 since they are all similar. Check the pinouts for each

You might try Jeff at https://avsubaruconversions.com Also, I think Smallcar will create a harness from scratch. -- Warren 89 Westy 88 Tintop 70 Westy

I am buying a new harness because it seems I have multiple shorts in the harness on the motor section between grey plug and sensor plugs. I have sourced several on the internet but seems like I should