开云体育

These are 110w and semi rigid. Tony Tony Billera tony.billera@... 206 605 2650 linkedin.com/in/tonybillera Please consider the environment before printing this email. Thank you.

I have a 40 watt on the stern rail, bought from Arizona wind and solar. Works well for similar purposes. ** James H. Wilson, Jr. Attorney & Counsellor at Law By appt. only: 4860 Cox Road, Suite

We are so happy with our light leaf solar panel. It’s been terrific especially since it comes with brackets that attached to the pushpit. It’s also easily adjusted and when folded down it fits

Hi, I'm the newish owner of a S36 hull #1. I did a map of all seacocks.? There are 2 in the aft lazerettes that are very hard to access. If i climb in, i can't reach them to operate. In an emergency

If you prefer not to install on a dodger or Bimini this product is very good. LightLeaf Solar lightleafsolar.com Tony Tony Billera tony.billera@... 206 605

Hi? ?New sabre 32 owner , Osprey in the Boston area.? Boat will be on a mooring and so? I need solar power to trickle charge the 2 12 volt batteries and to provide power to bilge pumps when

Hi Rob, Yes, I have had annoying slow leaks in the threads, which after much head scratching I traced to the taper vs straight incompatibility. Pipe compound fixed it. The Shur-flo adapters should

Single lever faucets from plumbing supply or big box are a great way to go. Less $$ and better quality than “marine” faucets. Single Lever use less water. Less time water running and adjusting

Hi Foster, yes, after I compared the price of the new model and the service kit, counted my time toward another project, and factored the likely chance of lasting and durable success, I realized it's

The threads on sink faucets are 1/2" straight, not tapered. Most single piece hose barb adapters are 1/2 " NPT, i.e. tapered. They will screw together but Teflon tape will not prevent the threads from

From my experience trying to rebuild my older foot pumps I would just replace it.? I bought rebuilt kits for 2 of them and do to the age of the plastic (being brittle) they housings broke almost

Happy spring everyone. Trying to fix a couple of small leaks I have at the sink and shower fixtures under the head/vanity counter.? Is there a trick to getting these to stop dripping?? I cutoff a

I have the same issue on my 362 and haven’t figured out the fix. I emailed Glen at Sabre a few years back and he wasn’t able to help. It almost seems that the bolt is installed into the bulk head?

Hi David, How are you? ?I think you surveyed my boat about 3 years ago. I just painted my bottom yesterday and used one gallon. ?I use Micron CSC. ?Most seasons I can get pretty good coverage

Similar situation on my 28-1. Advice please. Ted Brumleve Louisville, KY Sweet Pea [email protected]> wrote:

One of the flat head screws on a stanchion base on our 362 is loose/able to be turned and there is a bit of rust weep coming from under the base. It is the inboard aft screw of the forward stanchion

Although not a Sabre any more, with our S 402 still sitting in the Bahamas , where she became a TCL in Hurricane Dorian on the 1st September 2019 , I still sail our Catalina 42 Mk 2 on Lake Ontario

Hope you have many new adventures with your new boat. Best. -- Foster 1987 Sabre 42 C/B Hull #17

Thanks all. Bells and whistles on this project for sure. Figured am doing this once, so as a friend says, if you are doing something might as well overdo it. Thanks Dave for a contact name at

Friend in my harbor was still sailing his 362 at 93. Not single hand.