开云体育

As I have said previously, Sigma Drive is totally worth it.? Best price I found was King Propulsion.

Bill - To your questions about shaft alignment, my research showed that aligning to a tolerance of 0.010" was the "spec", however I aligned to 0.004" or less on my shaft. ?I did the alignment both on

Hi Ted, Oh that is right, thanks for jogging my memory. You can’t buy lenses from them they want you to buy the whole lid assembly. Allison Lehman Swiftsure Yachts allison@... Cell:

Hi Allison, I think Lewmar calls them lids, not lenses. My mistake. I bought from Defender. Link:

forgive the typo- Lower. Here’s a better view- ?I found and used an existing set of stern braces from Oswego Marina when headed out the benefit I still could use the Bimini, but obviously it could

I agree with Jim. Allison Lehman Swiftsure Yachts allison@... Cell: 510.912.5800 Fax: 510.860.4640 ?

Ted did you do the job yourself? If so where did you get the lenses? Lewmar doesn’t like you changing the lenses on the Ocean Series so they just don’t sell them.

Mark, you might try reverse and then neutral vs staying in revers. The torque on the gear box is not trivial the sailing and locking the prop in reverse. Allison Lehman Swiftsure Yachts

In placing the mast for my 36 estimated 55’ air draft on the boat’s length, the stern and bow only did not cause any evident deflection in the mast. As you may want to lover onto the cabin top for

Sounds more like a transmission problem than a Max Prop problem. --

Does anyone have photos they can share regarding mast cradles for overland transport of a 30+ft Sabre with a 50+ft long mast?? Specifically, I have a S362 with a 53ft mast, but I expect any Sabre

Hi, I replaced the roof hatch lenses a few years ago. They were Lewmar ocean series. Kind Regards, Ted Mendham Blue Pearl II, 1998 Sabre 362

Eric, thanks very much for forwarding that useful thread on engine mounts for the 362. It seems to answer Tim's question that the mounts were originally on 5" centers. Interesting that my mounts have

Looking for any advice on a current issue with my Max Prop Easy. When sailing- when we normally put the transmission in reverse to stop the shaft from spinning and to feather the prop. Recently we

Hi Bill, See below. Bushings Inc has a 5” mount that is not listed on their web site. Despite lots of suggestions from this group, I could not find reasonably priced 5 inch mounts. If I were to do

Yes.

Bill - Have you removed an engine mount to see if the mounting holes are original or if there are more than 2 holes per engine mount? ?The reason I ask is everything I am seeing shows the 35D having

I have a Westerbeke W21 that I have tore down and have many parts for it. I was told the motor ran before I bought it but the exterior was in fair to poor shape. I am only keeping the parts I know are

Thanks everyone for chiming in. Measurements on the boat today show the deck cutout is 20.375" square, outer dimension of hatch flange is 22.5" square, and height is 2" all of which are pretty close

Is it to stop drips from going in? Allison Lehman Swiftsure Yachts 510 912-5800 cell 510 860-4640 fax allisonleh@...