开云体育

I have a Pi-3 based PiHatU. ?If I leave J1 disconnected, the Pi boots normally. I’ve check the wiring to the Pi test points… no shorts, no solder bridges & the wire colors appear connected to the

Thanks for the responses. Stupid me had one of the USB ports on the Shari plugged in with an extension cord to keep it operational so once the programming port was re-engaged all is well. SMH -- Jack

?Barry nowhere in clicking either of those two working links did I see waiting. I can see the repeater information on Supermon and DV switch shows the dashboard with information in every field. Hope

Everything looks fine to me, does it not look fine to you?

Nevermind I guess I didn't ask the question right, thanks think. I know what I was trying to say or type? , too many hours staring at the screen,.? ?Disregard the post Barry

Yes the address works I know that, what I asked if u see on that link down we're your would see, the node were you're connected too's information the callsign of the repeater , on in that area of the

Do you have a SHARI PiHat or PiXX? This is most likely a low voltage problem caused by your Pi3 power supply. Does the Pi3 boot OK when your SHARI is not plugged into it? Plug an HDMI monitor into

Is anyone else experiencing immediate pi reboot looping during initial startup ?! ?All I see is the initial Linux boot sequence, then it constantly repeats….

“ Errno 2] No such file or directory: '/dev/ttyUSB0'” Looks like it is not plugged in as the tty device is missing.

Are you using the HamVOIP image? Are you programming a SHARI PiHat or PiXX?

Barry, You said this: http://n8dad.ddns.net:49735/ supermon/link.php?nodes=57687 ( http://n8dad.ddns.net:49735/supermon/link.php?nodes=57687 ) that just says "waiting" in were it should say node

This is my response from entering 818-prog in the correct directory after executing the bash shell command from the main menu. Rebooting didn't help. [root@KA9TQC-537060 sbin]# 818-prog Traceback

Patrick:? Thanks!? As a new AllStar user, this has been very helpful with getting audio levels set correctly.

“Link” I mean LoL Bill Paulus KD2EOY Vice President SCARA WWW.K2BR.COM Southern Counties Amateur Radio Association

I don't think u could access the link that has me local IP address in it could ya lol. The one that's 192.168 1.5

Look fine when I click your links Bill Paulus KD2EOY Vice President SCARA WWW.K2BR.COM Southern Counties Amateur Radio Association

I boosted your post and followed. Good day sir.

i have hamvoip and dvswitch installed on Rpi everything is working fine, now i see that after installing dvswitch also i can connect to supermon just fine but it says "Waiting" were node information

I posted about it there yesterday when I put it online, but feel free to spread the word. It has gotten quite a bit of use in the last 1.5 days. And, yes, before anyone asks, I am aware of the problem

N2DYI - Thank you for your efforts on the parrot. I linked from my ID-5100A over a Shari/PiHat hotspot. On my first tx, the parrot reported my audio level as low. I repeated my tx in a slightly louder