开云体育

Thanks Mason, I will give that a try. I did log into the Pi without the SHARI connected and tried to reconnect the WiFi, it could see all the connections around except my phone which is very strange.

Simon: Hey man hang in there I’ve been down the road too on connecting a iPhone and it can be a little frustrating. I have a SHARI node and a RPi 4B. Try this to use your phone to get into your RPi.

Thanks everyone, some good information to go forward. -- The views I present are that of my own and NOT of any organisation I may belong to. 73 de Simon, VK3XEM.

Hi Simon, Can you connect to the pi with keyboard and monitor? Alternatively if you have an old router you could plug it into, you could configure it over a LAN without intenet access, just using SSH

If you are having issue with wifi maybe the PI itself has a issue. Maybe swap the PI or image a new SD card and start over. We have built many PI based devices and sometimes its just the PI. Darrell -

I have virtually no experience using WiFI so I searched the HamVOIP.org website.? Have you looked at https://www2.hamvoip.org/wireless_howto.pdf ( https://www2.hamvoip.org/wireless_howto.pdf ) on the

I am ready to smash this SHARI, how the hell do I get it connected again? -- 73 de Simon, VK3XEM.

If I recall, /etc/resolv.conf is set to 127.0.0.1 by design, something to do with the HamVoIP dns-based node look-up system. There is a local resolver installed. This having been said, I changed

Thanks Darrell, it is an Android and I have checked to see if it has changed IP addresses and it has not.? It has just not reconnected for some reason. -- 73 de Simon, VK3XEM.

That's most bizarre. Not heard of that one happening before.

The reason it may not connect is because the IP addresses for your wireless and wired connections are different. Remember, Allstar connects to you as well as you connecting to it. Whether that happens

If its a iPhone then search this group for other iPhone issues. The newer IOS only has a two out of ten successful connection after reboot. The other thread gives clues on how to increase the odds.

I went to a friend's place as I only? have a mobile phone for Internet and used his router to set up my new SHARI and got it all working perfectly.? Then I set it up using my phone's WiFi hotspot

Thanks again Darrell. I have wireless working now. There was a problem in /etc/resolv.conf. The nameserver was pointing to 127.0.0.1 I changed it to point at my router instead and it lit right up

OK, so HAMVOIP runs on ARCH LINUX this website will be your best resource for a while https://wiki.archlinux.org/ Ping is just ping ==> in BASH type ping www.google.com (screenshot below). If you

Thanks Darrell. I used the wifi setup function that’s included on the main screen. It connected to the router and I was able SSH into it but it wouldn’t register with the Allstar server until I

If you are using the HAMVOIP version of allstar the wifi drivers are built in. All you need to do is boot from the SD card and answer all the questions. You need a monitor, keyboard and mouse at

Thanks.? Things are starting to make a little more sense now. I've finally got Allstar, Echolink and the COS LED working.? My next project is to get it working wirelessly. From what I've been

You enter a different code for CDCSS than you do for CTCSS when you program SHARI. The following is copied (and slightly corrected for English) from the SA-818 Programming Manual which can be

I would much prefer this method of PL encoding. How is it implemented on a Shari node?